Instruction manual
7
THIS APPLIANCE IS EQUIPPED WITH PROTECTION AGAINST OVERHEATING. This safety is
triggered when the device is without water (thermal circuit breaker). To reset the unit,
wait for it to cool down and press the button under the base of the unit (do not press
too hard, it is normal for a metal rod to protrude).
USE OF THE APPLIANCE
Before first use:
When using for first time, don’t worry if a slight smoke and odor appear, they disappear very quickly.
It’s advisable to boil about 5L water in the appliance before using it for the first time.
✓ Open the lid and pour in water, do not fill the water and coffee boiler over the max water lever
indicator.
✓ Plug the unit into the convenience outlet:
• If you only want to boil water, place the percolator tube and the filter basket in the tank.
Pour water up to the water level indicator.
• If you want to brew coffee, place the percolator tube and the filter basket in the tank and
put the desired amount of coffee. Do not fill water over the filter basket.
✓ Install and lock the cover of the appliance.
✓ Press the bouton on “ON” position, the heating indicator will light up and the water starts to
heat up.
✓ Once the heat indicator turns OFF and KEEP WARM indicator turns ON, it means coffee or water
is ready and stays warm automatically about 45 minutes.
✓ When the liquid level indicates that the tank is empty, tilt the brewer slightly forward to benefit
from the remaining coffee in the bottom of the tank (level below the tap).
✓ Press the “OFF” button at the end of use and unplug the unit.
Note: Make sure that the percolator tube is fitted inside the water and coffee boiler? Otherwise, it
will not work properly.
Tips:
It is recommended to use ground coffee. Preferably do at least half the capacity of the appliance.
Quantity of coffee
The amount of coffee and / or water is variable according to your own taste
- For 5L of water, 1 bag of 250 grams of coffee
- For 10L of water, 2 bags of 250 grams of coffee