Instruction Manual
6
Before to use:
− Clean the hotplate and drip tray in warm soapy water. Place your appliance on the level and stable
surface.
− Preheat a few minutes without food and at maximum temperature, then allow to cool down. A small
emission of smoke or a slight odor can be released; this is normal and should not worry; make sure the
room is well ventilated.
− Lightly coat the plate with a little cooking oil.
USING
1. Insert the control probe (8) fully into the socket (5) of the hotplate.
2. Slide the grease drip tray (2) into the slide bar under the grease drip dram (3)
3.
You can spread vegetable oil on to the non-stick grilling surface (4) if you so wish
4.
Connect the feed plug on to an adapted feed source
5. Plug the cord into a power outlet and turn the power ON.
6. Set the desired temperature by means of the temperature control “0/1/2/3/4/5”. When the
thermostat light on the control probe switches off, the desired cooking temperature has been
reached and the Grill is ready to use.
Note1: The thermostat light on the control probe indicates the Grill is heating. This light will remain
ON until the set temperature has been reached and then will cycle ON and OFF throughout cooking.
This will ensure that the Grill always maintains the selected temperature. The preheat time will
depend on the heat setting selected, if a high heat setting is selected, a longer preheat time required.
Note 2: When barbecuing on high heat settings, the Grill will generate smoke. Selecting a lower
setting will reduce smoke. Adequate ventilation is recommended.
7. Always turn the temperature control to “0” to switch off the grill.
8. Pull the plug from the connecting socket.
9. Carry the grill only by handles
10. Let the grill cool down out of the reach of the children.
CLEANING AND MAINTENANCE
1. Caution: Do not use wire brush or any abrasive items or liquids
2. Be very careful when you use cooking oil, if it is too hot i t can take fire
3. Always remove the plug from the socket before cleaning the plancha grill
4. Never immerse the appliance base in water
5. Ensure that the appliance has completely cooled down before cleaning or moving.
6. Clean the accessories with hot soapy water.
7. Use damp cloth to clean the appliance base.
8. The appliance is dishwasher compatible (please take off the thermostat first)
9. Store in a safe place: when not in use store your appliance and all its accessories and instruction
manual in a safe and dry place.