User manual
4
• The appliance starts to charge the internal battery, the green light flashes, and the green
light is always on when the battery is full.
Note:The product supports the function of charging and working at the same time, which can
be filled in 3 hours.
USE
1. Screw out the container bottle anticlockwise, take out the sponge then fill in less than 75%
alcohol or other liquid with a volume of 4 / 5(with water).
2. Let it stand for two minutes, make sure that the sponge fully absorbs the liquid
Note: The mixture must include water to allow vaporization. Do not smoke near the device, it
contains alcohol, it can be dangerous.
3. Place hand s on top of device near infrared sensor. At 0-12CM from hole, spray starts.
4. Put the sponge back and tighten the container anti-clockwise, cover the bottom shell.
5. Press on / off button (blue light long on), it is ready to use.
6. Press twice to shut down the appliance. The appliance be switched off if it exceeds 24 hours
not work.
Procedure to observe for battery’s end of life
The appliance batteries must be removed before discarding the equipment. Please follow the
procedure below:
Ensure that your appliance is disconnected so as to reduce any risk of electrical shock. Discharge the
batteries fully.
Remove the protection cover situated in a location where you connect the mains voltage adapter
and it is removed so as to access the batteries compartment. Carry a screwdriver to remove the
screw.
Remove the batteries from the equipment. Cut the cables and tab connecting the batteries in the
printed circuit and remove them.
ATTENTION: THESE NI-MH CELLS MUST BE RECYCLED OR ELIMINATED IN ACCORDANCE WITH THE
EQUIPMENT SCRAPPING.
Do not burn, dismantle, crush or break out the batteries because they can release toxic substances.
Do not expose them to extreme temperatures.
Drop them in the batteries recycling bins designed for this purpose or return them to your retailer.