Page is loading ...
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
F
F
O
O
R
R
C
C
O
O
F
F
F
F
E
E
E
E
P
P
E
E
R
R
C
C
O
O
L
L
A
A
T
T
O
O
R
R
- 1 -
OPERATION INSTRUCTION
BEFORE USING COFFEE PERCOLATER, READ ALL INSTRUCTIONS BELOW.
1. General information.
- Coarsely ground coffee is the most suitable for this appliance.
- Never immerse the appliance in water.
- Never switch on the appliance, if there is no water in tank.
- Always use appliance on a dry, level, heating-resistant surface, away from any edge. Be sure hands are
dry.
- The appliance just can be used in room. And the environment temperature should be between0°-40℃
THE APPLIANCE MUST BE EARTHED.
2. Installation
a. Before using the appliance, first clean the filter basket, filter cover, percolator pipe and inside of tank with a
non-abrasive detergent.
b. Place the appliance upright on a firm, flat surface. Do not put it at the place where there is water and do not
clean it by water spray.
c. Place the grate in the tank.
d. Plug the appliance into a grounded socket (while the appliance is switch off)
e. Insert the appliance unit to the base of black plastic pad. (only for CP06)
THE APPLIANCE IS NOW READY TO USE.
3. Making coffee
Warning! The appliance just can be used to making coffee.
When working,please let the outside of the appliance keep dry.
When working, do not touch the surface of the appliance.
When making coffee, at least half of total capacity of the machine must be utilized.
- Coarsely ground coffee is preferable.
a. If another sort of coffee is used, a paper filter is required.
b. Fill the tank with COLD water in accordance with the amount of coffee required.
c. Seal the filter basket by attaching the filter cover.
d. Place the percolator pipe and the filter basket in the tank. Making sure that the foot of the percolator pipe
is positioned firmly on the cavity of the base.
e. Replace the top cover on the appliance.
f. Switch on the appliance. The lamp in the switch should now light up.
g. When the green pilot goes on, the coffee is ready and will be kept warm automatically.
h. When about three cups of coffee remain in the tank or when coffee can no longer be seen in glass gauge,
unplug cord from electric outlet and turn switch “OFF”.
i.To reheat cold coffee, simply plug appliance in and turn switch “ON”. Be sure the basket and percolator
pipe are remover. There must be at least 12 cups of coffee in the tank to reheat.
4. Heating water for instant beverages.
Plain water may be heated in your appliance for use with instant beverages.
Simply fill the clean appliance with COLD water to the desire cup level and place percolator pipe and
empty basket into position as for making coffee . Plug appliance in and switch to “ON” position until the
perking stops.
Unplug the appliance when less than 3 cups of water remain.
When appliance is used to heat water only. It must be thoroughly cleaned “WELL” after each use. In addition
to special weekly cleaning using vinegar to move mineral deposits. If these deposits are not removed, pitting
of the metal can occur and result in damage to the appliance. See special cleaning instructions.
5. Cleaning after use.
a. Remove the filter basket and percolator pipe from the tank and empty the filter basket is easier if the coffee
dregs have dried up slightly.
b. Rinse the filter basket, filter cover and percolator pipe under the tap.
c. Rinse the inside of tank until it is clean. The appliance is now ready to use again.
- 2 -
6. Special cleaning.
Improper cleaning of appliance, especially the heating unit “WELL” will affect performance, resulting in
weak, lukewarm coffee and may even cause appliance to stop perking. To keep the appliance working
properly regularly follow these instructions.
If appliance is used daily, a special cleaning every 2 week, or every week used for heating water is necessary
to thoroughly clean the heating unit “WELL”. If not kept clean, the appliance will not work properly.
If the appliance is rusty, soft cloth can be used to clean and disinfect the appliance by using household
disinfection cleaner.
See the other sheet of instructions of the special cleaning tool for coffee percolator.
7. Maintenance.
a. Clean the filter basket, filter cover and top cover with a non-abrasive detergent and then dry them off with a
soft dry cloth.
b. The inside of the tank and the percolator pipe are made of stainless steel and can be cleaned with a scouring
agent, possibly in combination with a scouring pad.
c. If the appliance is to function properly, the cavity in the middle of the base must be free of lime scale and
coffee deposits. Use a scale remove if necessary.
d. The inside of the glass gauge can be cleaned with the aid of the enclosed pipe cleaner. First unscrew the
gauge cap, then insert the pipe cleaner into the glass gauge from above. Brush may also be used to clean
percolator.
Do not dismantle the glass gauge in the process.
e. To clean faucet, unscrew handle. Move a brush up and down though faucet, then insert brush through
opening inside appliance to clean faucet connection.
Wash faucet handle in hot soapy water and rinse. Replace faucet.
Do not use baking Soda to clean appliance as it can discolor and pit the metal！
8. This appliance is not intended for use by persons（including children）with reduced physical,sensory or
mental capabilities,or lack of experience and knowledge ,unless they have been given supervised to ensure
that they do not play with the appliance .
9. Thermal cut-out.
The appliance must be unplugged before it can reset. The appliance is fitted with a thermal cut-out. If this is
activated, the appliance will turn itself off, although the lamp in the switch will remain on. In order to make
the appliance operational again, the reset button on the bottom of the appliance must be pressed once the
appliance has COOLED DOWN. If the appliance still does not work, you should consult your dealer. This
safety device may have been switched off during transport. If so , follow the above instructions.
Model No. : CP06
Voltage : 220V -240V/100 V -120 V 50/60HZ
Watts
: 1150W
Dimension: 30.00cm X30.00cmX47.00cm
Weight
: 3.60KG
Volume : 6Liters
Model No. : CP10
Voltage : 220V -240V/100 V -120 V 50/60HZ
Watts
: 1500W
Dimension: 34.00cm X 34.00cmX48.50 cm
Weight
: 3.90KG
Volume : 10Liters
.
Model No. : CP15
Voltage : 220V -240V/100 V -120 V 50/60HZ
Watts
: 1500W
Dimension: 34.00cm X 34.00cm X59.00cm
Weight
: 4.20KG
Volume : 15Liters
10.Explosive and list
- 3 -
CP06，CP10，CP15
序号
Name
1
Handle of upper cover
2
Mat of upper cover's handle
3
Upper cover
4
small locating bush
5
Big locating bush
6
six-hole tray
7
spray stem
8
seal ring of spray stem
9
stand of tap
10
tap
11
Seal ring
12
tank
13
Indicator light
14
PTC warm slice
15
Warm slice flat
16
Resetting automatically
thermostat
17
Hot cup heat plate
18
Reset thermostat by handle
19
Reset thermostat by handle
20
Flange nut
21
Reset link
22
screw
23
spring
24
Base board
25
supporter
26
Heating element
29
Seal ring of hot cup
30
Hexagonal nuts
31
Flat gasket
32
Hot cup
33
Spot welding screw
34
Round bottom welding
35
switch
36
lock
37
Cable components
38
Handle of tank
39
Flat gasket
40
Base seat of spray stem
41
screen
42
Cover net
43
screw
44
Seal ring of cover
/