Instruction manual
WWW.LIVOO.FR
1) Insert the flexible tube into the canister air intake on the front of the vacuum cleaner. Push in until
you hear a "click", which ensures that the hose is securely in place. To remove, press the 2 latches
on either side and pull towards you to release.
2) Insert the hose handle into the telescopic tube.
3) You can adjust the height of the telescopic tube by pressing the black button on the tube to raise or
lower it.
4) Install the floor brush at the base of the telescopic tube.
This has 2 positions: for hard floors or carpets and rugs. Press the pedal on top of the brush to
change the position. The position with the brush is for carpets and rugs to allow for deep cleaning.
5) Insert the dust bag. To do this, open the dust bag lid by pulling the opening handle on the front.
Place the dust bag in the dust bag holder. Close the lid.
CAUTION! NEVER USE THE APPLIANCE WITHOUT THE BAG. This will cause irreparable damage to the
appliance.
Note: you can obtain replacement dust bags compatible with your DOH129 cleaner from your dealer
or on the Livoo.fr website.
USE
1. Pull out the required length of cable. Never pull the cable past the red mark to avoid damage to the
automatic rewind system.
2. Connect the unit to the mains.
3. Turn on the unit by pressing the on/off button on the top of the product.
The airflow can be adjusted with the hand control on the plastic handle (Schema.C) to prevent the
brush from sticking too much to the floor.
The nozzle/brush tip is especially recommended for grooves, hard-to-reach corners and textile
surfaces.
After use, switch off the appliance by pressing the on/off switch and unplug it.
Trigger the automatic cable rewind by pressing the rewind button.
DO NOT LEAVE THE CABLE OUT OF THE UNIT AFTER USE. Doing so may cause accidents and damage to
the unit.
Note: After use, do not pull on the cable to disconnect it. Do not roll or step on the cable.
MAINTENANCE AND CLEANING
Note: Always unplug the appliance before cleaning and wait for it to cool down completely.
• Clean the body of the appliance with a damp cloth and allow it to dry.
• Wash the filter at the back of the appliance regularly with slightly soapy water and allow it to dry
before replacing the filter and filter cover correctly.
Caution! Using the appliance without a dust filter will clog the motor and lead to breakdowns or
faster obsolescence.
We recommend replacing the filter every year (depending on its condition).