Amperes CS210 User manual

Brand
Amperes
Model
CS210
Type
User manual

This manual is also suitable for

Amperes CS210, CS510, CS610

These ceiling speakers are designed for general purpose use, such as paging and background music in hotels, small offices, and public areas. They are easy to install, with spring clips that hold the speaker securely in place. The slim edge design and low profile height make them visually appealing, and the epoxy mesh protects them from rust.

The CS210 is a 2" speaker with a power rating of 6W, while the CS510 and CS610 are 5" and 6" speakers with a power rating of 6W as well. All three speakers have a frequency response of 150 - 19 KHz for the CS210 and 120 - 19 KHz for CS510 and CS610, and an SPL of 92 dB.

Amperes CS210, CS510, CS610

These ceiling speakers are designed for general purpose use, such as paging and background music in hotels, small offices, and public areas. They are easy to install, with spring clips that hold the speaker securely in place. The slim edge design and low profile height make them visually appealing, and the epoxy mesh protects them from rust.

The CS210 is a 2" speaker with a power rating of 6W, while the CS510 and CS610 are 5" and 6" speakers with a power rating of 6W as well. All three speakers have a frequency response of 150 - 19 KHz for the CS210 and 120 - 19 KHz for CS510 and CS610, and an SPL of 92 dB.

Guide to Installation
Connect cable
www.ampereselectronics.com
INSTALLATION GUIDE
CS210 2” 6W 100V CEILING SPEAKER
Introduction
CS210 is a general purpose 2" 6W 100V line ceiling speakers which comes
complete with metal grille and back enclosure. Built with high quality ABS plastics.
It is suitable for paging and BGM delivering clear and crispy sound reproduction.
Among suitable places for installations are :
- Hotel corridors and room foyers
- Small office rooms
Cut the ceiling hole
86 mm
Ceiling
Cut the ceiling using the template with 86mm diameter
Connect the incoming speaker cable to the cables from the
speaker according to the required power rating, as:-
- Black - red ~ 6W
- Black - yellow ~ 3W
- Black - Green ~ 1.5W
Cut off the loose cable’s conductor to avoid shorting or tape
them with insulation tape.
Slot the conduit
Upon completion of cable termination, the connector can be
inserted inside the conduit, and thereafter slot in the conduit into
the speaker hole at the back enclosure. The overall installation
would look neat.
Flexible conduit
20mm Ø
cut off unused cable
connector
Conduit
Slot
Flip spring clips
Spring Clip
Flip the spring clips fully upwards
Ceiling
Ceiling
1
2
Insert speaker to ceiling hole
Slot the speaker into the cut hole in slant position initially by the
first spring , and thereafter the second spring
1
2
Installation complete
Ceiling Ceiling
Flat and sharp screw driver
The installation is complete as shown. If is required to uninstall the
speaker, use a flat screw driver to pull it if down the speakers
edge.
Please do it carefully as not to damage the ceiling. The grille can
be opened for inspection by turning it clockwise.
CS210 : 2” 6W 100V Line Ceiling Speaker
CUT OUT TEMPLATE FOR CS210 CEILING SPEAKERS
www.ampereselectronics.com
ISO 9001: 2008
Design & Manufacture of Public Address Equipment and Systems
Certicate No. 16895 / A / 0001 / UK / En
C U T O U T D IA M E T E R : 86 M M
Cut out hole
Grille border
INSTRUCTION MANUAL
www.ampereselectronics.com
Introduction
Precision Design, Absolute Confidence
5” 6W 100V Line Ceiling Speaker
CS510
Public Address Systems
CS510 is a general purpose and cost effective ceiling speaker with
nominal power rating of 6W 100V line. With only quality of finishing and
optimum sound reproduction in mind, they shall be the best choice to
enhance your installations ! and cost effective too.
Among the outstanding features are the installation mechanism - spring
clips which is flexible to flip but strong in holding.
The slim edge design, coupled with the low profile height, brings out the
coziness of the installation.
It is suitable for Speech and soft background music playback in areas
such as :
Hotel corridors / lobbies
Offices
Shopping centres for general paging and pipe in music
Public areas
Features
Slim edge with low side profile
High quality ABS with optional FR
Easy spring clip installation
Epoxy mesh for rust proof
Non enclosure as optional
Technical Specifications
Speaker
Power rating
Diameter
Cone type
Impedance
Freq Response @ 1KHz +/-3 dB
SPL @ 1W / m ( +/-3dB ) 1 KHz
6W 100V line ( Max 10W )
5” ( 125 mm )
Dual Cone
8 Ohm
150 - 19 KHz
92 dB
Matching Transformer
Tapping ( 100V line input )
Primary impedance
Secondary impedance
1.5 / 3 / 6W 100V line
6.7 K / 3.3 K / 1.67 K Ohm
8 Ohm
Physical Dimensions
Grille / enclosure
Cutting hole dimension ( mm )
Overall size
Weight
Colour
Metal grille / ABS plastic
145 mm
165 dia x 110 h mm
740 gms
White
Packing Information
Carton box dimensions
Weight
Packing quantity
360 W x 400 H x 710 D mm
22.70 kg
24 uts
Circuit Diagram
COM
1.5W
3W
6W
8 Ohm
Secondary to
speaker
Black
Red
Yellow
Green
Transformer power tapping
www.ampereselectronics.com
Guide to Installation
CS510 : 5” 6W 100V Line Ceiling SpeakerInstruction Manual
ISO 9001: 2008
Design & Manufacture of Public Address Equipment and Systems
Certicate No. 16895 / A / 0001 / UK / En
Cut a hole at ceiling
145mm
Ceiling
Cut a 145mm diameter hole at the ceiling.
Connect cable
Flexible conduit
20mm Ø
cut off unused cable
connector
Colour code:-
- Black - Red ~ 6W
- Black - Yellow ~ 3W
- Black - Green ~ 1.5W
Cut off the loose cable’s conductor to avoid shorting or tape them with insulation
tape.
Insert conduit:
Upon completion of cable termination, the connector can be inserted inside the
conduit, and thereafter slot in the conduit into the speaker hole at the back enclosure.
The overall installation would look neat.
CeilingCeiling
1
2
Insert speaker to ceiling hole
Slot the speaker into the cut hole in slant position initially by the first spring and
thereafter the second spring
1
If it is required to uninstall the speaker, use a flat screw driver to pull down the speak-
er’s edge.
2
INSTRUCTION MANUAL
www.ampereselectronics.com
Introduction
Precision Design, Absolute Confidence
6” 6W 100V Line Ceiling Speaker
CS610
Public Address Systems
CS610 is a general purpose and cost effective ceiling speaker with
nominal power rating of 6W 100V line. With only quality of finishing and
optimum sound reproduction in mind, they shall be the best choice to
enhance your installations ! and cost effective too.
Among the outstanding features are the installation mechanism - spring
clips which is flexible to flip but strong in holding.
The slim edge design, coupled with the low profile height, brings out the
coziness of the installation.
It is suitable for Speech and soft background music playback in areas
such as :
Hotel corridors / lobbies
Offices
Shopping centres for general paging and pipe in music
Public areas
Features
Slim edge with low side profile
High quality ABS with optional FR
Easy spring clip installation
Epoxy mesh for rust proof
Non enclosure as optional
Technical Specifications
Speaker
Power rating
Diameter
Cone type
Impedance
Freq Response @ 1KHz +/-3 dB
SPL @ 1W / m ( +/-3dB ) 1 KHz
6W 100V line ( Max 10W )
6” ( 150 mm )
Dual Cone
8 Ohm
120 - 19 KHz
92 dB
Matching Transformer
Tapping ( 100V line input )
Primary impedance
Secondary impedance
1.5 / 3 / 6W 100V line
6.7 K / 3.3 K / 1.67 K Ohm
8 Ohm
Physical Dimensions
Grille / enclosure
Cutting hole dimension ( mm )
Overall size
Weight
Colour
Metal grille / ABS plastic
185 mm
205 dia x 110 h mm
840 gms
White
Packing Information
Carton box dimensions
Weight
Packing quantity
440 W x 430 H x 660 D mm
19.20 kg
18 uts
Circuit Diagram
COM
1.5W
3W
6W
8 Ohm
Secondary to
speaker
Black
Red
Yellow
Green
Transformer power tapping
www.ampereselectronics.com
Guide to Installation
CS610 : 6” 6W 100V Line Ceiling SpeakerInstruction Manual
ISO 9001: 2008
Design & Manufacture of Public Address Equipment and Systems
Certicate No. 16895 / A / 0001 / UK / En
Cut a hole at ceiling
185mm
Ceiling
Cut a 185mm diameter hole at the ceiling.
Connect cable
Flexible conduit
20mm Ø
cut off unused cable
connector
Colour code:-
- Black - Red ~ 6W
- Black - Yellow ~ 3W
- Black - Green ~ 1.5W
Cut off the loose cable’s conductor to avoid shorting or tape them with insulation
tape.
Insert conduit:
Upon completion of cable termination, the connector can be inserted inside the
conduit, and thereafter slot in the conduit into the speaker hole at the back enclosure.
The overall installation would look neat.
Insert speaker to ceiling hole
Slot the speaker into the cut hole in slant position initially by the first spring and
thereafter the second spring and
1
If it is required to uninstall the speaker, use a flat screw driver to pull down the speak-
er’s edge.
2
CeilingCeiling
1
3
2
3
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Amperes CS210 User manual

Brand
Amperes
Model
CS210
Type
User manual
This manual is also suitable for

Amperes CS210, CS510, CS610

These ceiling speakers are designed for general purpose use, such as paging and background music in hotels, small offices, and public areas. They are easy to install, with spring clips that hold the speaker securely in place. The slim edge design and low profile height make them visually appealing, and the epoxy mesh protects them from rust.

The CS210 is a 2" speaker with a power rating of 6W, while the CS510 and CS610 are 5" and 6" speakers with a power rating of 6W as well. All three speakers have a frequency response of 150 - 19 KHz for the CS210 and 120 - 19 KHz for CS510 and CS610, and an SPL of 92 dB.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents