Single Bowl Inset/Undermount Sink
SNK4960
HD027060
Care and Maintenance
Do not use abrasive cleaning
products as these may scratch the
surface of the sink
Care & Maintenance
- Paint
- Chemicals
- Hot Fat
Installation
Measure and Cut
Fitting - Undermount
Fitting - Inset
1
2
3
4
7
5
6
Use the template to mark for sink cut out.
Note: Recommended distance from the back of the worktop for an inset application
is 105mm to the edge of cut out.
Apply a continuous
bead of silicone around
the rim of the sink.
Wipe around the sink rim and worktop
removing any dust or grease.
Apply a continuous bead of silicone around
the rim of the cut out where the sink will sit.
Fit the sink to the
worktop and tighten
the sink clips (x8)
on the underside to
secure.
Note: Do not use
power tools to tighten
screws.
Fit the sink to the underside of the worktop making sure
the bowl is concentric to the cut out. Push down rmly to
adhere silicone seal.
Note: Silicone the thread of the screws for extra strength.
Wipe away any excess silicone
Drill eight holes around the pencil
line and t the metal inserts,
tapping rmly into place.
NOTE: Glue the insets into the holes
and make sure the inserts do not go
over the pencil line.
WARNING: SHARP EDGES
Drill four holes, one in each corner of the
marked area. Use a jigsaw to cut-out.
The worktop will require notching on the
underside for the overow in an inset sink
application.
For undermount sink installation a jig
must be used with a router. The router will
achieve a smooth nish to the worktop
cut-out. Sand to a nal nish.
Note: Worktop cut edge should be sealed
with a waterproof varnish.
With the worktop upside down, lay the
bowl over the cut out and mark around the
edge.
Note: Make sure the bowl is concentric
with the cut out.
Inset
Undermount (Timber top application)
Template
5mm
40mm
Top surface of Worktop
5mm
2mm
6mm
Worktop
Underside
Worktop
Underside
Sink
Pe
ncil Line
Glue
x8
Wipe around the sink rim
and worktop removing
any dust or grease.
Sink Rim
x8
Silicone
Sealant
/
