- Paint
- Chemicals
- Hot Fat
Single Bowl Inset/Undermount Sink
1.5 Bowl Inset/Undermount Sinks
SNK4940
SNK5830/ SNK5835
HD613032
Care and Maintenance
Do not use abrasive cleaning
products as these may scratch the
surface of the sink
Care & Maintenance
Cut plywood strips to the dimensions
shown. These will distribute the clamping
action of the brackets.
Note: DO not t the strips at this stage.
Installation
Measure and Cut
Fitting - Undermount
Fitting - Inset
1
2
3
4
8
5
6
7
Use the template to set up sink cut out.
Note: Recommended distance from the back of the worktop for an inset application
is 105mm to the edge of cut out.
Wipe around the sink rim and worktop
removing any dust or grease.
Apply a continuous bead of silicone
around the rim of the sink.
Wipe around the sink rim and worktop
removing any dust or grease.
Apply a continuous bead of silicone around
the rim of the cut out where the sink will rest..
Fit the sink to the
worktop and tighten
the sink clips (x8)
on the underside to
secure.
Note: Do not use
power tools to tighten
screws.
Fit the sink to the underside of the worktop making sure
the bowl is concentric to the cut out. Push down rmly to
adhere silicone seal.
Place the wooden strips to the underside of the sink rim.
Fit the brackets to the worktop inserts so they clamp onto
the wooden strips.
Note: Silicone the thread of the screws for extra strength.
Wipe away any excess silicone
Drill eight holes around the pencil
line and t the metal inserts,
tapping rmly into place.
NOTE: Glue the insets into the holes
and make sure the inserts do not go
over the pencil line.
WARNING: SHARP EDGES
Template
Worktop
Underside
Worktop
Underside
12mm
20mm
x4
Worktop
Underside
Sink
Pencil Line
Glue
x8
Sink Rim
Wooden
Strip
x8
Drill four holes, one in each corner of the
marked area. Use a jigsaw to cut-out.
The worktop will require notching on the
underside for the overow in an inset sink
application.
For undermount sink installation a jig
must be used with a router. The router will
achieve a smooth nish to the worktop
cut-out. Sand to a nal nish.
With the worktop upside down, lay the
bowl over the cut out and mark around the
edge.
Note: Make sure the bowl is concentric
with the cut out.
5mm
40mm
Top surface of Workto
p
5mm
2mm
6mm
Silicone
Sealant
Sealant
Undermount Sink
Inset Sink
Inset
Undermount
/
