Stainless
Steel
cleaners
Abrasive
cream
cleaners
Chlorine
or
Bleach
Acid
Alkali
Caustic
Washing
Up Liquid
Square Bowl Sink
SNK1442
HD815030
Care and Maintenance
Do not use abrasive cleaning products as these
may scratch the surface of the sink
Do not drop heavy objects onto the sink
Do not cut on or drag objects across the sink
1
2
3
4
8
7
5
6
Installation
Measure and Cut
Fitting
1
2
3
4
5 6
7
Use the measurements below.
Cut inner line.
Fit the top part of the clips and secure
so they bite into the underside of the
worktop.
Check the sink position before fully tight-
ening the clips.
Note: Secure clips around the bowl follow-
ing the numbering order shown.
Using the dimensions shown, cut out
the rebate for the overow pipe from
the underside of the worktop.
Apply sealant to the cut
edges, then wipe around the
cut out surface edge.
WARNING: SHARP EDGES
Back Edge
Fit the seal or for a more ush nish exclude
the seal and use silicone.
Fit the bowl to the worktop making sure
the sealer strip around the edge (if tted) is
correctly positioned. Fit the overow back box.
5mm
485mm
435mm
R83
x8
220mm 220mm
40mm
Top surface of worktop
15mm
20mm
20mm
Split the two clip sections, then t the
lower part to the xing plates on the
bowl.
Silicone
-
1
-
2
LAMONA SNK1443 Operating instructions
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
LAMONA SNK5836 Operating instructions
-
-
-
Silestone WOH8802 Operating instructions
-
-
-
-
-
