2. HySecurity
  3. SlideDriver II Heater

HySecurity SlideDriver II Heater Installation guide

  • Hello! I've reviewed the installation instructions for the HySecurity SlideDriver II Heater. This document provides a comprehensive guide on installing the heater unit to prevent freezing of gate operator components, complete with parts list, step-by-step installation process and wiring diagrams. I'm ready to answer any questions you may have about this manual.
  • What is the purpose of the heater?
    What should be done before installing the heater kit?
    What tools are needed for installation?
1D1157 Rev. B ©2023
The following instructions are intended to assist the
user in the installation of the heater unit for use on
the SlideDriver II gate operators. The heater prevents
components from freezing and not operating properly.
Please read all assembly instructions before installing the
kit.
PARTS
Heater strip
Heater cord
Romex connector
Cover plate
Thermal switch
Heater contactor
HARDWARE
 
 
 
 
TOOLS
Standard wrenches
 
PREPARATION
1. Remove cover.
 Set the power switch to OFF.
 Carefully unclamp the drive wheels.
4. 
 

 Install the thermal switch in the hole and fasten with
Figure 4
Power
Switch
Loosen
cover
screws
Lift
cover
SLIDEDRIVER II HEATER
CAUTION

necessary precautions to avoid electrical shock.
Figure 1. Remove the Cover
Set Power Switch to OFF

Figure 4. Install Thermal Switch
1
2
Thermal Switch
Area
support.hysecurity.com
HEATER WIRING (FIGURE 10 AND
FIGURE 11)
11. Connect the heater cord to the heater strip; be sure to
bend the terminals up so that they contact no metal
surfaces.
 Use the romex connector and lock washer and route
the heater cord through the bottom hole in the pivot
Figure 8
 Take the romex connector and tighten it down onto
the heater cord.
14. 
SLIDEDRIVER II HEATER
 Install the heater strip vertically in the drive post with

Figure 7



the paint of the drive post. Complete the mounting

Figure 7. Install Heater Strip
Figure 8. Strain Relief
Strain Relief and Cover
Remove Pivot Arm Assembly
 Slide the two pivot arms and motors out as a

INSTALL THE HEATER
7. 
8. Remove the pins. Lift the pivot arms to make the pins

Remove Pivot Arm Pins
D1157 Rev. B ©2023
SLIDEDRIVER II HEATER

THERMAL
SWITCH
NO
TO MOTOR
HEATER KITS:
Drawing REV B
MODELS COVERED:
B
B
FINISH INSTALLATION
 Clean any debris from drilling the thermal switch hole.
 
mounting brackets and reconnect any disconnected
wires.
 Reinstall the pivot arms and pins.
 Carefully clamp the drive wheels.
 Set the power switch to ON and test cycle the gate.
 Close the electrical box and install the cover.
 Take the heater cord up to the electrical box and run
it through one of the knockouts. Use the plastic cord
connectors to attach to the panel wall.
 Install the heater contactor in the electrical box and
connect the heater contactor to the power supply or

17. Connect one lead of the heater cord to terminal T1 of

18. 

 
4support.hysecurity.com
SLIDEDRIVER II HEATER
THERMAL
SWITCH
NO
TO VFD
TO VFD
HEATER KITS:
MODELS COVERED:
B
B
Drawing REV B
Figure 11. 
/