•HDDCopyCruiserIDE/SATAHigh-Speed™

•QuickStartGuide(thisdocument)

•IDEHardDriveTrays

•SATAHardDriveTrays

•PowerCord

•UserGuideCD

•RegistrationCard

•StandComponents(350131only)-6pieceswithscrews

1. Openthedrivetraydoorsbyliftingthetabontheleftsideofeachdrivebayyouwishtouse.

2. TaketheHardDiscDrive(HDD)andalignthedrive’sIDEplugtothelowerrighthandsideofthedrivebay.

3. SlidetheHDDintothedrivebayuntilitstops.Thedrivewillstillbeabout1inchoutsideofthebay.Whenthedoorisclosedit

willpushandplugtheHDDintotheduplicator.

1. LoadthesourceHDDandthetargetHDDsintotheHDDCopy

CruiserIDE/SATAHigh-Speed.Thesystemwillauto-detectthe

harddrives.Afterthedriveshavebeendetected,ascreen

similartotheonetotherightwillbedisplayed.

Note:BeforecopyingbesurethatthecapacityofthetargetHDDisequaltoorlargerthanthesourceharddrive.

2. PressOKtostartcopying.Thesystemwillauto-detecttheharddrives.Thefollowinginformationwillbedisplayed.









3. DuringthecopyprocesstheHDDCopyCruiserIDE/SATA

High-Speedwilldisplayprogressinformation.



Note: Thecopyingspeed,capacityanddurationmayvary

fromoneharddrivetoanother.

4. Onceduplicationiscomplete,ajobstatusscreenwillbe

displayed.

