Page is loading ...
A. Headboard (1 pc) B. Footboard (1 pc)
D. Center Support (1 pc)
E. Wood Slat System (1 pc)
C. Siderail (2 pcs)
F. Center Leg (3 pcs)
Platform Bed
Contains One (1) Bed and Hardware
IMPORTANT NOTE:
Carefully remove all the parts
from the box. Arrange on a at
surface and verify you have all
of the following parts and hardware.
PARTS LIST
HARDWARE LIST
(Continued on back)
K. Large Hex Key (1 pc)J. Small Hex Key (1 pc)H. Small Screw (2 pcs) I. Large Screw (9 pcs)G. Bolt (3 pcs)
TOOLS REQUIRED:
Phillips Screwdriver
A
SIZE: QN, DB
STEP 1
STEP 2
STEP 4
ASSEMBLY INSTRUCTIONS
STEP 3
A
Attach the Footboard (Part B) to the Side Rails (Part C) by
sliding the Side Rail attachment over the pre-installed
bolts on the Footboard. Attach the Headboard (Part A) to
the Side Rails (Part C) by sliding the Side Rail attachment
over the pre-installed bolts on the Headboard. Securely
tighten the bolts on the Headboard and Footboard using
Large Hex Key (Part K).
Screw the Center Legs (Part F) into the Center Rail (Part D)
using Bolts (Part G). Secure each Center Leg using Small Hex
Key (Part J).
Insert the Center Rail into the brackets on the Headboard
and Footboard. Secure the Center Rail in place with Small
Screw (Part H) using the pre-drilled holes and a Phillips
Screwdriver. Secure the Center Rail into both the Head-
board and the Footboard.
Roll out the Wood Slat System (Part E) with the strap facing
down and secure it in place with nine Large Screws (Part I)
using the pre-drilled holes and a Phillips Screwdriver.
K
I
H
J
G
K
/
