2. BLOTZ
  3. B10-CS-305

BLOTZ B10-CS-305 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ B10-CS-305 Hospital Roof model. This document details how to assemble the L-shaped roof using included wall and lift pieces. It also provides guidance on the order of assembly and the use of glue and a modeling knife. I'm ready to help with any questions you might have about its construction.
  • What kind of glue is needed for assembly?
    What tools are required?
    What are the steps for assembling the walls?
10mm 5x5 ‘L-Shape’ Hospital Roof
B10-CS-305
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Roof Section (B10-CS-305)
Remove the roof piece and wall sections from the
sprue.
Starting with wall piece ‘A’ run clockwise around the
building adding side ‘B’, end ‘C’, side ‘D’, side ‘E’ and
finally end ‘F’.
Now apply the wall covering to walls ‘D’ then ‘E’
as shown above. Glue the other wall coverings
into place. Remove the sections of the lift from the sprue.
Glue together as shown above.
Then glue into place on the roof.
Finally, glue a rectangular support to the back of
each wall section at the base (see above).
The finished roof section.
/