MOUNTDOG MOUNTDOG Photography Lighting Kit,6.6X 10ft Backdrop Stand System and 900W 6400K LED Bulbs Softbox and Umbrellas Continuous Lighting Kit for Photo Video Shooting,etc. User manual

Brand
MOUNTDOG
Model
MOUNTDOG Photography Lighting Kit,6.6X 10ft Backdrop Stand System and 900W 6400K LED Bulbs Softbox and Umbrellas Continuous Lighting Kit for Photo Video Shooting,etc.
Type
User manual
1
MOUNTDOG
Photography Lighting Kit ,6.6x 10ft Backdrop Stand System and
900W 6400K LED Bulbs Softbox and Umbrellas Continuous
Lighting Kit for Photo Video Shooting,etc.
2
SAFETY PRECAUTIONS:
1.Become thoroughly familiar with this product before use. Run through at
least one practice assembly and breakdown before you schedule a shoot.
2.Never leave the lighting unsupervised when in use. Keep children or
incompetent person away from lighting equipment.
3.If the power cords show signs of wear or damage, they should be replaced
before use.
4.Wait until bulbs are completely cool before touching or removing them.
5.Never use in a wet environment.
6.Never move the appliance by pulling the cord. Make sure the cords do not
come in contact with bulbs. Do not wind the cord around the appliance.
7.Place stands/lripods on flat surface to prevent toppling.
8.Do not touch the metal parts near the bulbs while in use. these parts may
become very hot.
9.Do not let umbrella touch light bulb when in use.Light bulb will get hot and
can rum Light bulb.will get hot and can ruin the softbox or start a fire.
3
2x50cmx70cm Softboxes 2x33’’Translucent Umbrella 2xBulbs Holders
2x Energy saving bulbs 2x LED bulbs 3xbackdrops (6.6x 10ft
(45W,5600k) (85W,2700-6400K) black,white green)
1xBackdrop support stand 6XBackdrop clamps 2x Sandbags
(6.6x 10ft/2.3mx3m)
4xLight stands 2xRemote control
(79"/200cm height)
1xKit carry bag
4
ASSEMBLY INSTRUCTIONS:
Installation steps of soft box
1.Open the softbox,push the 2.Install the bulb on the 3.Put the bulb holder knob
fixed with interface to the end bulb holder fixed on the light stand
4. Attach the big soft cloth to the 5. A softbox assembly complete
outside of the soft box.
Installation steps of soft umbrella
1.Insert bulb into light holder as 2.Attach light holder to tripod/ 3.Insert umbrella pole
shown and screw bulb until it fits light stand as shown.Be sure to into hole in light holder
snug into the socket tighten screw on back of light and tighten screw on
holder for stability side of light holder to
keep umbrella stable
5
INSTALLATION INSTRUCTIONS
(6.6x 10ft/2.3mx3m Backdrop Stand)
ASSEMBLY INSTRUCTIONS
1. Open the lamp holder
2.Tighten sliding seat knob of lamp holder
2.
Adjust height and tighten knob
4.Push the button and alignment direction then connecting them with each other
6
5.Put the bracket with hole to the top of the light stand
6.Insert the protective metal gasket and locking the knob
7.Finished
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

MOUNTDOG MOUNTDOG Photography Lighting Kit,6.6X 10ft Backdrop Stand System and 900W 6400K LED Bulbs Softbox and Umbrellas Continuous Lighting Kit for Photo Video Shooting,etc. User manual

Brand
MOUNTDOG
Model
MOUNTDOG Photography Lighting Kit,6.6X 10ft Backdrop Stand System and 900W 6400K LED Bulbs Softbox and Umbrellas Continuous Lighting Kit for Photo Video Shooting,etc.
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents