Page is loading ...
Backdrop Support Roller System
User Manual
7
Repeat the previous steps for the installation of other rollers.
You can pull the chain to lift up/down the backdrop.
Note
The backdrop poles shown in this user manual is for illustrative purpose only. They
are not included in the product.
8
Note:
You can install the brackets vertically if needed.
Safety Instructions
1. When installing the bracket, ensure that it is securely installed first and
regular check its security before every time of use. The screws must be
fastened tight enough.
2. Every time before use, ensure that the product is securely installed.
3. Every time before use, ensure that the rollers are correctly installed.
4. Children should not use the product as it might cause bodily damage.
5. The installation of this product should be carried out by at least two people.
Package Contents
Bracket x 2
Screw x 10
Screw Sleeve x 10
Washer x 10
Spring Lock Washer x 10
Weight x 4
Nut x 10
Roller (with gear) x 4
Roller (without gear) x 4
Chain x 4
6
Hang the backdrop pole on the brackets.
2
7
Installation Instructions
1
Specifications
Suitable Backdrop pole diameter
1 3/4” (4.5 cm)
1. Place the bracket on the desired positions of your ceiling. (Please take
the length of your backdrop pole into consideration.)
2. Use a pencil to mark down the holes of the brackets.
4
Insert the rollers into your backdrop pole (not included), you can rotate the
handle of roller to expand its expansion stick to fill up your backdrop pole for
securing.
5
Thread the chain through the gear of the roller and the weight and connect it
back to its end.
3
6
Expansion Stick
Weight
2
Drill holes on the ceiling for the screw sleeves.
3
Screw
Screw Sleeve
Bracket
Washer
Spring Lock Washer
Nut
Install the brackets on your ceiling as shown.
4
5
/
