Page is loading ...
Package Contents
Piece Description Quantity
A Puck Light 1
Hardware Contents
Mounting
Screws
Qty.2
Tools Required
Phillips
Screwdriver
Drill
Warranty
A
AA
C
12"
12"
1
5-YEAR LIMITED WARRANTY
The manufacturer warrants this product to be free from defects in materials and workmanship for a period of five (5) years from date of purchase. This
warranty applies only to the original consumer purchaser and only to products used in normal use and service. If this products is found to be defective,
the manufacturer's only obligation, and your exclusive remedy, is the repair or replacement of the product at he manufacturer's discretion, provided that
the product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect, or mishandling. This warranty shall not apply to
any product that is found to have been improperly installed, set-up, or used in any way not in accordance with the instructions supplied with the product.
This warranty shall not apply to a failure of the product as a result an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other
failure not relating to faulty material workmanship. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or
incidental loss or damage, including labor/expense costs involved in the replacement or repair of said product.
Contact the Customer Service Team at [email protected] or visit www.getinlight.com
Contact the customer service department at [email protected]
We commit to respond to emails within 24 hours - and sooner, if possible!
We are devoted to solving problems and offering the best service to our customers.
Questions, problems, missing parts?
PLEASE READ THESE INSTRUCTIONS BEFORE COMMENCING
INSTALLATION AND RETAIN FOR FUTURE REFERENCE.
is registered trademarks of Inlight Co. Ltd. All Rights Reserved.
Installation Guide
ATTACH YOUR RECEIPT HERE
Purchase Date __________________
Swivel Design
LED Puck Light Kit
Model #
IN-0107-1-XX-XX
Surface installation
(Wires under a shelf or cabinet)
Surface installation
(Wires on top of a shelf or cabinet)
Recessed installation
● Separate the trim ring by pushing on the back of the
LED puck housing.
● Install the trim ring to the bottom side of the cabinet
by inserting two mounting screws into the mounting
holes on the bottom of each trim ring.
● Take the cords from the LED puck housing and feed the
cords through the outlet hole of the trim ring. Do not pull
the cords tight as you will need to finish screwing in the
trim ring.
● Tighten the screws and push the LED puck housing
into the trim ring while pulling the cord tight.
● Locate positions where LED pucks are to be mounted.
● Use the enclosed template to drill 1/2" hole to pass the
connector through the shelf.
● Repeat step 1 and 2 in the surface mounting (Wires
under a shelf or cabinet) installation section.
● Thread the wires from the LED puck housing through the
hole and compress the springs and push the LED puck
housing in the trim ring.
● Locate positions where LED pucks
are mounted.
● Separate the trim ring by pushing on
the back of the LED puck housing.
● Use the enclosed template to drill a
2-3/8" hole.
● Thread the wires from the LED puck
housing through the hole and insert
the fixture into the hole.
Questions, problems, missing parts?
Before returning to the store, contact Inlight Customer Service
Retain this manual for future use.
Lighitng & Spacing
WARNING
Installation Procedure
2
RISK OF ELECTRIC SHOCK RICK OF FIRE
● DO NOT USE IN WET LOCATIONS.
● USE INDOORS ONLY.
● USE ONLY INSULATED STAPLES OR PLASTIC TIES TO SECURE
THE CORDS
● ROUTE AND SECURE THE CORDS SO THAT THEY WILL NOT
BE PINCHED OR DAMAGED.
NO SERVICEABLE PARTS
NON-REPLACEABLE LEDS
LED LIGHT OUTPUT IS STRONG ENOUGH TO INJURE HUMAN
EYES. PRECAUTIONS MUST BE TAKEN TO PREVENT LOOKING
DIRECTLY AT THE LEDS WITH UNAIDED EYES FOR MOR THAN
A FEEW SECONDS.
RICK OF FIRE
● NOT INTENDED FOR ILLUMINATION OF AQUARIUMS.
● NOT INTENDED FOR USE ABOVE STOVES, COOK TOPS, SINK OR
OTHER HEAT PRODUCING APPLIANCES, SUCH AS COFFEE
MAKERS, TOASTERS, OR TOASTER OVENS.
● NOT INTENDED FOR RECESSED INSTALLATION IN CEILING OR
SOFFITS.
● DO NOT CONCEAL POWER SUPPLY CORD OR LINKING CORDS
INSIDE A WALL, CEILING, SOFFIT, KITCHEN CABINET, OR SIMILAR
PERMANENT STRUCTURE.
● DO NOT RUN THE POWER SUPPLY CORD OR LINKING CORDS
THROUGH HOLES IN WALLS, CEILINGS OR FLOORS.
● TO REDUCE THE RISK OF FIRE, DO NOT INSTALL IN A
COMPARTMENT SMALLER THANT 6" X 6" X 6".
Safety Information
V. 2019
/
