Danfoss VO2 Variable Output Board (Analog Output Board) Installation guide

Hello! I am an AI chatbot trained to assist you with the Danfoss VO2 Variable Output Board (Analog Output Board) Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

3/99 Doc #

Identification

Dimensions

Addressing

Mounting

I/O Network Configuration

INSTRUCTIONS

VO2 Variable Output Board

Each VO2 connected to an AKC 55 must have a unique

address starting with 01. Each address switch has an

arrow pointer which is also a screwdriver slot for setting the

address.

The VO2 board is designed for 3” snap track mounting. It

can be mounted (1) inside of a Danfoss I/O enclosure, or

(2) in control panels where codes and good electrical

practice permit.

Up to 120 I/O nodes (OI8, RO8, SI8, AKC 16x Smart Case

Controllers, etc) can be connected to one AKC 55.

A maximum of 5 cable runs (1 shown) can be used to connect

any combination of nodes to the AKC 55.

The total length of all I/O cable runs (including stubs) is limited

to 5000 feet. Use point-to-point (“daisy-chain” connections

between boards.

The last I/O board on each cable run must be terminated.

Terminations are supplied with the AKC 55 controller as shown.

When necessary, individual I/O boards can be placed on

individual stubs up to a maximum of 25 feet long off a main

cable run.