MIN 75℃ SUPPLY CONDUCTORS
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
INSTALLATION INSTRUCTION
For Wall Mount Fixture Item#345-37B (New. 05/08/2019)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
LA-3134E
PREPARATION (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
in a clear area. Take care not to misplace any small parts
necessary for installation.
3. Thread the nipple (D) part way into the center hole of the
crossbar (C). Note: The length of the nipple into the
crossbar may be adjusted if necessary.
4. Use the lock washer (B) and hex nut (A) to secure the
nipple (D) into the crossbar.
5. Attach the Crossbar (C) to the junction box with the two
Junction box screws (E) (Size: #8-32N*L0.5”) as shown.
The side of the Crossbar marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig. 2, making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect the fixture’s
ground wire directly to the crossbar (C) using the green
screw provided. After the wires are connected carefully
tuck them inside the Junction box.
COMPLETING THE INSTALLATION
6. Place the fixture back plate (H) over the nipple (D) so the
nipple protrudes through the center hole. Holding the
fixture in place, thread the cap nut (F) onto the end of the
nipple (D) until fixture is secured to the wall.
7. Install (2) two medium base bulbs (G) up to 60 watts each
or CFL or LED equivalent (not included) in accordance with
the fixture specification. — DO NOT EXCEED THE
MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
8. Insert the plastic sheet (I) into the glass frame to protect
the glass shade (J) from scratch.
9. With the wider end on upper side, slide the glass shade (J)
into the decorative glass holder (K).
10. Pull out the plastic sheet (I) carefully.
Your installation is now complete. Return the power to the
junction box and test the fixture.
Set# A-010
- Crossbar
- Ground screw
- Mounting Screw*2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
I
NARROW END
WIDER END
D
C
B
A
H
J
G
F
E
K
/
