Minka Lavery 4134-84 User manual

Type
User manual
INSTALLATION INSTRUCTIONS FOR 4134
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
Fig.1
ASSEMBLING THE FIXTURE (Fig. 1)
1. Shut off the power at the fuse box or circuit breaker
box. If necessary, remove the old fixture including the
mounting hardware.
2. Carefully remove the new fixture from the carton and
check that all parts are included as shown in the
illustration.
3.Thread the rod (F) onto the nipple (G).
MOUNTING THE FIXTURE (Fig.1)
4. Thread the two mounting screws (A) (Size: #8-
32*1.2”L) part way into the crossbar (B). Secure
crossbar (B) to the junction box (not provided) with
junction box screws (C) (Size: #8-32*0.6”L). The length
of mounting screws (A) into crossbar (B) may be
adjusted if necessary. The side of the cross bar
marked “GND” must face out.
CONNECTING THE WIRES (Fig.2)
5. At this point, connect the electrical wires as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
or bare copper), connect the fixture’s ground wire to
it. Otherwise, connect the fixture’s ground wire
directly to the mounting plate using the green screw
provided. After the wires are connected, tuck them
carefully inside the outlet box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Align canopy (D) onto mounting screws (A) and
secure with finials (E).
7. Install the light bulbs (Included) in accordance with
the fixture’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the
outlet box and test the fixture.
Fig.2
Set#
-Crossbar
-Ground screw
-Mounting screw*2
-Junction box screws*2
A-016
  • Page 1 1

Minka Lavery 4134-84 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI