Crosley CF3008-NA Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Crosley CF3008-NA Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Roots Rack Kitchen Cart
CF3008-NA
1pc
2pcs
Top
PART LIST
Left diagonal Leg
2pcs
A
B
C
HARDWARE LIST
28pcs
J
Short Bolt(M6*28mm)
2
I
Q
4pcs
1pc
Allen Key(M4mm)
Long Bolt(M6*38mm)
N
L
8pcs16pcs
Handle Washer(M6mm)
K
16pcs
Flat Washer(M6mm)
Spring Washer(M6mm)
M
F
2pcs
2pcs
Towel Bar
Drawer handle
P
1pc
Wrench(M17mm)
O
G
12pcs
2pcs
Wood Dowel(M8mm)
Locking Caster
Right diagonal Leg
D1/D2
Shelf
2pcs
E
2pcs
Rod(M8mm)
H
2pcs
Caster
Step 1.
Step 2.
Attach Towel Bar(F) & Handle Washer(N) to Legs (B&C) using
Long Bolts (I) & Allen Key (Q) .
Repeat this step for the remaining two legs .
B
C
I
F
N
N
I
press up
press down
Place Top (A) face down on flat surface ,press up and down the slide joint ,
to pull out the drawer .
X 2
3
press up
Step 3.
Step 4.
Set legs (B&C) into place on Top (A) using Wood Dowels (O) .
J
J
Attach Legs (B&C) to Top (A) using Flat Washers (K) ,Spring
Washers (L) ,Short Bolt (J) and Allen Key (Q).
A
4
NOTE: Do not fully tighten all bolts in this step .
Step 5.
Align Shelf (D1) with Legs (B&C) as shown below. Insert four wood dowels through
the outer holes in the shelf (D1) into the Legs( B&C) to help hold the shelf in place.
Install Flat Washers (K), Spring Washers (L) and Short Bolt (J) through the inner
holes in the shelf into the Legs (B&C). Tighten with Allen Key (Q).
5
NOTE2: .Once both shelves are in place, fully tighten all bolts.
Once tight, remove wood dowels.
NOTE1: Do not fully tighten bolts at this time.
Repeat this for Shelf (D2) .
Insert four Wood Dowels (O)
into the four legs (B&C)
through the shelf first.
Bolt the shelf into place
by using Flat Washers (K),
Spring Washers (L),
Short Bolt (J) and Allen Key (Q).
Step 7.
Step 6.
Attach Locking Casters (G)&Casters (H) using wrench (P) .
Attach Rod (E) to Legs (B&C), using short Bolts (J) and Allen Key (Q) .
C
Carefully turn cabinet right side up ,with casters on the floor.
6
Step 8.
7
Left drawer
has a brand in it .
Q
Attach Drawer Handle Washers (N) and Drawer Handles (M) to
drawers using Short Bolts(J) and Allen Key (Q) .
Step 9.
Insert drawers into cabinet .
/