Step 1.
Attach back panel (part A) to left arm panel (part D) using short bolts (part #1), flat washers
(part #4), hex nuts (part #3), wrench (part #5) and allen wrench (part #6).
NOTE: Please do not fully tighten bolts until unit is fully assembled.
Lay left arm panel (part D) down on a .soft flat surface, such as carpet, as shown below
Step 2.
short bolts (part #1) , long bolts (part #2) , flat washers (part #4) , hex nuts (part #3),
wrench (part #5) and allen wrench (part #6).
NOTE: Please do not fully tighten bolts until unit is fully assembled.
Attach seat panel (part B) to back panel (part A) and left arm panel (part D) using
A
#6
#1
#4
#1
x2
#4
x4
#3
#5
x1
x2
#6
x1
#4
#3
#5
D
#6
#1
#4
#4
#3
#5
#6
#2
#4
#4
#3
#5
#4
#2
#6
#4
#3
#5
#2
x4
#4
x12
#3
#5
x1
x6
#6
x1
#1
x2
3
A
D
B