2. Riverside Furniture
  3. 2903

Riverside Furniture 2903 Assembly Instructions

  • I have reviewed the assembly instructions for the Riverside table model 2903. This document details the necessary steps for assembling the table, including attaching the legs and shelf, and the optional addition of casters. I'm ready to assist you with any questions you have about the assembly process or the included parts.
  • How should the table top be placed during the initial assembly?
    When should the bolts be fully tightened?
    What should be done before assembly process?
    Where should the casters be attached, if used?
Made in Viet Nam
Craftsman Home Tables
Assembly Instructions
Component And Hardware List
Be sure to check all packing material carefully for small parts, which may have come loose inside the
carton during shipment. Separate, count and check all parts against the Components and Hardware List below.
Leg
email: info@riverside-furniture.com
Page 1 of 1
Shelf
Table Top
1 PC.
(A) (B) 4 PCS. (C) 1 PC. (D)
4mm
Allen Wrench
1 PC.
12 PCS.
Bolt:
Ø5/16 x 50mm
(F)
Flat Washer
Ø 5/16"x19mm
(E)
Spring Washer
Ø 5/16"
(G)
12 PCS.
12 PCS.
Wrench 13mm
(I) 1 PC
(H) 4 PCS.
Caster
Item #2903
LIFT-TOP COCKTAIL
ASSEMBLY PROCEDURE:
1. Place Table Top (A) upside
down on a soft, non-abrasive
surface such as a blanket or carpet,
or its own packaging materials.
2. Attach the Legs (B) to the four
corners of the Table Top (A) by
using the Bolts (D), Spring Washers
(F) & Flat Washers (E), as shown in
STEP 1.
Do not fully tighten Bolts until
Step 2.
3. Assemble Shelf (C) to the Four Legs by usingthe Bolts (D),
Spring Washers (F) & Flat Washers (E), as shown in DETAIL A.
Pull the Shelf snug to the Legs and tighten Bolts using the
Allen Wrench (G). Pull the Legs snug to the Top Assembly and
tighten Bolts at the top of the Legs.
4. If the Casters (H) will be used: Attach to the bottom of the
Shelf and tighten with the Wrench (I), as shown in DETAIL B.
To prevent possible damage to some types of flooring, never
roll casters on unprotected hardwood or vinyl flooring.
5. Carefully set the completed Table
upright.
THANK YOU FOR YOUR PURCHASE.
DETAIL B
STEP 2: STEP 3:
(E)
(F)
(G) (D)
DETAIL A
(I)
(H)
STEP 1:
(E)
(F)
(G)
(D)
1 PC.
/