Magnadyne WC-12V-W Installation guide

Type
Installation guide

This manual is also suitable for

Wall Mount USB / 12V Power Outlet
Models: WC-12V-B and WC-12V-W (Rev. D)
Models: WCP-12V-B and WCP-12V-W
Installation Instructions
WC-12V-IMUM Rev. G 10-08-19
© 2019 Copyright Magnadyne Corporation magnadyne.com
Installation
Black Wire with Red Stripe
Connect to a 12V power source.
Black Wire
Connect to chassis ground.
Warnings
ANY UNAUTHORIZED CHANGES OR MODIFICATIONS TO THIS EQUIPMENT MAY
VOID THE USER’S AUTHORITY TO OPERATE IT.
• TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT INSTALL THE
UNIT IN A PLACE EXPOSED TO DIRECT SUNLIGHT OR EXCESSIVE HEAT OR
HUMIDITY. AVOID PLACES WITH TOO MUCH DUST OR THE POSSIBILITY OF
WATER SPLASHING OR GETTING WET.
• THIS DEVICE IS INTENDED FOR CONTINUOUS OPERATION.
• TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK AND ANNOYING
INTERFERENCE, USE ONLY THE RECOMMENDED ACCESSORIES.
• IN CERTAIN VEHICLES THE
ADAPTER WILL DRAW POWER EVEN WHEN VEHICLE
IS TURNED OFF AND DEPENDING ON USAGE MAY DRAIN THE VEHICLE’S BATTERY
.
Use the proper power supply. This product is designed for operation with a
negative grounded 12V DC battery system. If the product is used with the
improper system it may cause a fire or an accident.
• This product must be installed and used in accordance with this installation
instructions. Any alterations to this product that enables it to be used in any way
other than intended or designed could result in an accident causing injury or death.
Magnadyne Corporation disclaims any and all liability that may result from failure
to install and operate in any other manner in which this unit was intended.
Do not disassemble, modify the unit or attempt to repair the product yourself.
If the product needs to be repaired, consult your dealer.
Caution
1
1
/4
2
3
/4
Faceplate
(Not Supplied)
Template
Faceplate Screws
(Not Supplied)
Mounting Screws
(Not Supplied)
+12 Volt
Ground
NOT FOR HOME USE OR 110V-220V APPLICATIONS
magnadyne.com
Wall Mount USB / 12V Power Outlet
Models: WC-12V-B and WC-12V-W (Rev. D)
Models: WCP-12V-B and WCP-12V-W
Operation Instructions
© 2019 Copyright Magnadyne Corporation
USB Charging Ports
Power Indicator
Do not insert any metal objects into
the sockets as fire or electrical shock
may occur.
USB Charging:
USB ports are capable of charging 2 devices simultaneously.
Charges most USB powered devices: i-series devices, smart phones,
Mp3 players and USB powered devices.
Inserting a USB Cable:
Gently insert the USB drive into the slot.
Note 1: If a USB connector does not insert, DO NOT FORCE it into the
slot, flip the connector over and try again.
Removing a USB Cable:
Pull the USB connector straight out of the socket. Do not pull the USB’s
cable to remove the USB connector from its socket. Damage may occur.
12V Power Socket (APO)
Warnings Introduction Power Indicator
The green LED illuminates when the
outlet has power.
Inserting a VPA:
Insert the VPA into the socket making sure to fully insert the charger.
Removing a VPA:
To remove the charger pull the VPA charger out of the socket. Do not
pull the vpa’s cable to remove the charger.
DO NOT USE CIGARETTE
LIGHTERS WITH THIS UNIT.
WC-12V-IMUM Rev. G 10-08-19
The WC-12V-B/W USB Charger offers two
USB charging ports and an automotive
power outlet (APO). The WC-12V-B/W USB
outlet is able to charge most current
electronic devices, two at a time, including
smart phones, tablets, cameras, e-readers
and MP3 players.
Specifications:
Automotive Power Outlet Output Rating: 12VDC, 15A
Charging Output Rating:
USB #1: 5V3A/9V2A/12V1.5A
USB #2: 5V2.4A
Wire Terminals: #16 AWG
Working Temperature: 32˚ to 104˚F (0 to 40˚C)
USB Connector Compatibility: USB-A
Type 1.1/2.0/3.0 devices
Maximum Power Consumption: 120 watts
  • Page 1 1
  • Page 2 2

Magnadyne WC-12V-W Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI