Assembly & Installation Instructions
MODEL: 900007 900008
IMPORTANT SAFETY INSTRUCTIONS:
•
Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure
full compliance with N.E.C. requirements. If there are any questions, please contact a qualified electric
contractor.
•
Warning: This product can expose you to chemicals including lead, which is known to the State of
California, to cause cancer or birth defects or other reproductive harm. For more information,
please go to www.P65Warnings.ca.gov
•
Caution: Electrician installation highly recommended. All glass is fragile, use care when handling glass
component(s) and or lamp(s). Read instructions carefully and turn electricity off at the main circuit breaker
panel before beginning installation.
Important Notice:
This is a generic instruction sheet used for various fixtures.
The shape and style of fixture / glass / shade / diffuser may vary.
(Required Supply Circuit: 120V, 60Hz. Watt: 3*E26*60W Max) Compatible Bulb Type (NOT Included)
The mostly suggested bulb type is 9W LED ST58 bulb
COMPONENTS INCLUDED IN THE PACKAGE
Rod/Light cluster/Frames/Arms/Strips/Cap/Chain/Canopy with mounting parts/Crystals Parts included
in parts bag
ASSEMBLY & INSTALLATION STEPS:
1. Open the box from top, take out all the components, parts bag and manual from the box carefully.
2. Check all the components against the parts list. Make sure get each parts on list. If any parts missing
or glass damage, please contact manufacturer at: [email protected] to get a replacement.
Parts are NOT included for which is shown as 0 under QTY.
PARTS LIST
Part Name QTY Code Part Name QTY Code
Junction Box
0
A
Screw
12
N
Leading Wires
0
B
Upper Frame
1
O
Wire Nut
3
C
Strip
3
P
Mounting Bracket with Studs
1
D
Light Cluster
1
Q
Mounting Screw
2
E
Bottom Frame
1
R
Canopy with Collar Loop
1
F
Ground Wire
1
S
Cap Nuts
2
G
Fixture Wire
2
T
Chain Locker
2
H
Chain
1
U
Loop
1
I
Ring
1
V
Disc
1
J
Bolt and Washer
3
W
Cup
1
K
Bolt Nut
3
X
Arm
3
L
Crystal
56
Y
Central Rod with Nipple
1
M
Light Bulb
0
Z
Missing parts? Glass damage? Any questions?
Please email us at : support@micsiu.com
We are always here to help you fix the problems you are facing.
3. Refer to the illustration while doing assembly and follow the steps as below:
I
Assemble the upper frame (O), three strips (P) and bottom frame (R) using the screws (N). Refer to the
illustration so each part and the top/bottom ends are correctly distinguished before assembly.
II
Use the bolt nuts (X) to fix three arms(L) to the bolts (W) on the cup (K), attach the other end of the arms
(L) onto the upper frame (O), fix with screws (N).
III
Release the ring (V) from the nipple of central rod (M), insert the rod (M) through the hole of the cup (K),
place the disc (J) on the cup, then use the loop (I), ring(V) to fix the disc(J), cup(K) and central rod (M).
Connect the light cluster (Q) with central rod (M) from the bottom openning of fixture frame. Fixture wires
(T) go through the central rod (M) and loop (I) for later assembly.
IV
Adjust the studs on the mounting bracket (D) to a proper protrusion if necessary. As for a test, slide the
canopy (F) onto the studs to figure if the cap nuts (G) cover the protrusion properly. Thread the studs
toward the junction box (A) a little bit if it protrudes from the canopy (F) too much.
Attach the mounting bracket (D) to the junction box (A) by two mounting screws (E).
V
Use the chain locker (H) to assemble the canopy (F) and loop (I). Now the fixture assembly is completed.
Wires (T) go through the canopy (F) for wiring.
VI
Connect wires according to the wiring diagram on the right.
VII
Slide the canopy (F) to the studs on the mounting bracket (D), then fix it with two cap nuts (G).
VIII
Hang the crystal (Y) onto the frame one by one carefully, and screw the light bulbs (Z) onto to socket.
Illustration of assembly and wiring:
I.
N, O, R
P
II.
W, K, X L
N, O
III.
I, V, J, K, M
Q
IV.
E, D
A
V.
F, H
I
VI.
B, S, T
C
VII.
G, F
D
VIII.
Y, Z
Q
GND
A
B
C
D
E
F
G
H
I
J
K
L
M
O
R
P
Y
Z
N
N
N
Q
S
V
T
U
W
X
/
