Arlec 62999 Operating instructions

Brand: Arlec

Model: 62999

Type: Operating instructions

COMPACT

Bell & Chime Transformer

Please read these instructions carefully

before installing the Arlec Bell & Chime

Transformer.

Important Notes

1. This transformer is designed for operation

on 8V or 12V output. Do not connect loads

simultaneously to both outputs.

2. The marked output of 1A is not the continuous

current rating. This rating is based on short

duty cycles of operation, as is normal for a bell

chime. The transformer is capable of delivering

a continuous current of 200mA, plus the short

duration peaks of 1A. More than one bell or

chime may be connected provided that the

ratings are not exceeded. Failure to observe the

above may result in permanent damage to the

transformer.

SPECIFICATION

Input: 240V 50Hz 3VA

Output Voltage: 12 or 8 Vac

Output Current: 200mA max continuous,

plus 1A peaks.

Max duty cycle 1 minute on

5 minutes off.

All wiring should be carried out by a licensed

electrical contractor.

Site the transformer in an accessible position as

close as practicable to the bell chime, the push

button door switch and a mains supply.

Four 25mm No.4 self tapping screws are supplied

with the transformer to ﬁx it into position.

1. Remove the cover from the 240V mains

connections by depressing the locking tabs with

a small screwdriver.

2. A knockout is provided on the side of the mains

cover to enable wires to be connected to the

transformer.

3. Switch off the power at the meter box. Connect

the Neutral wire of the mains electricity supply

to the transformer terminals marked N - 240V

50Hz. Connect the active wire through a circuit

breaker or switch (with air gap separation) to the

transformer terminal marked A - 240V 50Hz.

4. According to the voltage of the bell or chime

to be operated, connect the circuit wires to

the appropriate terminals as indicated on the

diagram.

5. Replace the mains connection cover by sliding it

into place over the locking tabs.

6. Switch on the power and check the operation of

your bell/chime.

CPIN368/2

Block Diagram

Transformer

AC Main

Supply

Push Button

Bell or

Chime

Circuit Breaker

CPIN00368I2.indd 1 5/09/11 4:48 PM

Arlec Warranty*

Arlec guarantees this product against defects of materials

and workmanship for a period of 12 months from the date

of purchase provided the product is used for its proper

purpose, in accordance with Arlec’s recommendations

and within such voltage and current limits as are

speciﬁed by Arlec in relation to the product. Arlec will

at its own option and cost make good, or replace this

product with the same or similar product and return it to

you, or provide a credit for any product manufactured or

supplied by it, which proves to be defective within the

limits set out above provided that no repairs, alterations

or modiﬁcations to the product have been undertaken or

attempted by anyone, other than Arlec or its authorized

agents. Should you wish to make a claim under this

guarantee, the product and proof of purchase must be

returned pre-paid by you to the place of purchase.

This guarantee is in addition to and does not take away

from any other rights and remedies you may have under

any relevant law.

Our goods come with guarantees that cannot be excluded

under the Australian Consumer Law. You are entitled

to a replacement or refund for a major failure and for

compensation for any other reasonably foreseeable

loss or damage. You are also entitled to have the goods

repaired or replaced if the goods fail to be of acceptable

quality and the failure does not amount to a major failure.

*Excludes Batteries

Please retain your proof of purchase for all warranty

claims.

For all Sales & Warranty enquiries

Arlec Australia Pty Ltd. (A.C.N. 009 322 105)

Building 3, 31-41 Joseph Street,

Blackburn North, Victoria, 3130

P.O. Box 1065, Blackburn North LPO

Blackburn North, 3130

Phone (03) 9982 5111

Fax 1300 360 650

[email protected]

CPIN368/2

240 V 50Hz INPUT

OUTPUT 1A MAX.

N A

APPROVAL No. V94055/E141-26

Knock out for side entry mains wiring

Four screw

holes for

mounting

12V AC

8V AC

Bell & Chime

Transformer

12V AC

CPIN00368I2.indd 2 5/09/11 4:48 PM

Arlec 62999 Operating instructions

Arlec 62999 Operating instructions

Arlec 62999 Operating instructions

Related papers

Other documents