Minka Group 72756-66G User manual

Brand: Minka Group

Model: 72756-66G

Type: User manual

INSTALLATION INSTRUCTIONS

For Model 72756-66G

W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig. 1

Fig. 2

HANGING THE FIXTURE (Fig. 1)

1. Shut off the power at the circuit breaker and

remove the old fixture including the mounting

hardware.

2. Carefully unpack your new fixture and lay out all

the parts on a clear area. Take care not to lose

any small parts necessary for installation.

CONNECTINE THE WIRES (Fig.2)

3. While supporting the fixture (C), connect the

electrical wires as shown in figure 2. If your post

has a ground wire (green or bare copper), connect

the fixture ground wire to it. If not, consult your

electrician for proper grounding. After the wires

are connected, tuck them carefully inside the post

cup (A).

COMPLETING THE INSTALLATION (Fig. 1)

4. Take off the roof (E) by loosening screws (D).

5. Install (4) four candelabra base bulbs up to 60

watts or CFL or LED equivalent (not included) in

accordance with the fixture specification.

DO NOT EXCEED THE MAXIMUM WATTAGE

RATING! (NE PAS DEPASSER LA PUISSANCE

NOMINALE MAXIMALE!)

6. Attach the roof (E) back to the fixture (C) with

screws (D)

7. Place the fixture (C) onto post cup (A) and secure

with mounting screws (B).

Your installation is now complete. Return power

to the junction box and test the fixture

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

Green or

Bare

Copper(G

round)

Minka Group 72756-66G User manual

Minka Group 72756-66G User manual

Minka Group 72756-66G User manual

Related papers

Other documents