Minka Lavery 72686-66 User manual

Brand
Minka Lavery
Model
72686-66
Type
User manual
INSTALLATION INSTRUCTIONS
Model #72686
READ AND SAVE THESE INSTRUCTIONS
WAR N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
BARE COPPER(GROUND)
Fig.2
FIXTURE
WIRES
WHITE
BLACK
(HOT)
WIRES
HOUSE
GREEN OR
WHITE
(NEUTRAL)
WIRES
HOUSE
(GROUND)
COPPER
BARE
FIXTURE
WIRES
BLACK
WIRES
FIXTURE
GREEN OR
HOUSE
WIRES
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off the power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in
a clear area. Take care not to misplace any small parts
necessary for installation.
3. Pull the black, white and ground wires out of post (A).
CONNECTING THE WIRES (Fig. 2)
4. While supporting the fixture, connect the electrical wires as
shown in Fig. 2. making sure that all wire connectors are
secured. If your post has a ground wire (green or bare
copper), connect the fixture ground wire to it. If not, consult
your electrician for proper grounding (Fig.2). After wires are
connected, tuck them carefully inside the post cup (A) (not
included).
COMPLETING THE INSTALLATION (Fig. 1)
5. Align the lantern (C) with post (A) and secure with screws (B).
(Fig.1)
6. At this point, unscrew hex coupling (J) and remove flat washer
(H), rubber washer (G), and roof (F). Next, unscrew the ball
nuts (D) and remove bracket (E).
7. Install (1) one type A bulb up to 100 watts or CFL or LED
equivalent (not included) in accordance with the fixture
specification. —DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
8. Replace the bracket (E) and secure with ball nuts (D).
Replace the roof (F), rubber washer (G), flat washer (H), and
secure with hex coupling (J). Screw in nipple (K), place cap
(L) and cap (M) over nipple (K) and secure with finial (N).
Your installation is now complete. Return power and test the
fixture.
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
ATTENTION – RISQUE D’INCENDIE, CONSULTER UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE
LES CONDUCTEURS DE LA DÉRIVATION SONT
ADÉQUATS.
  • Page 1 1

Minka Lavery 72686-66 User manual

Brand
Minka Lavery
Model
72686-66
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents