The Great Outdoors 8909-94 User manual

The Great Outdoors
Brand
The Great Outdoors
Model
8909-94
Type
User manual

This manual is also suitable for

INSTALLATION INSTRUCTIONS
Model # 8906/8909
READ AND SAVE THESE INSTRUCTIONS
WARNING ! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
1. Shut off power at the circuit breaker and remove the
old fixture including mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Pull the black, white and ground wires out of post
(E).
4. Connect the electrical wires while supporting the
lantern. If your post has a ground wire (green or
bare copper), connect the fixture ground wire to it. If
not, consult your electrician for proper grounding.
After wires are connected, tuck them carefully inside
the post cup (C) (Fig 1)
5. Align the lantern with post (E) and secure with
screws (D). (Fig 2)
6. At this point, remove screws (B), and top cover (A),
to install the 3*60W candelabra bulbs in accordance
with the fixture specification DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!
7. Replace the top cover (A) and secure it with
screws (B).
Your installation is now complete. Return power to
and test the fixture.
BARE COPPER(GROUND)
Fig.2
FIXTURE
WIRES
WHITE
BLACK
(HOT)
WIRES
HOUSE
GREEN OR
WHITE
(NEUTRAL)
WIRES
HOUSE
(GROUND)
COPPER
BARE
FIXTURE
WIRES
BLACK
WIRES
FIXTURE
GREEN OR
HOUSE
WIRES
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
PREPARING FOR INSTALLATION (Fig.1)
1. Shut off power at the circuit breaker and remove the old
fixture including mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
CONNECTION THE WIRES (Fig. 2)
3. While supporting the fixture connect electrical wires as
shown in (Fig. 2). If your post has a ground wire (green
or bare copper), connect the fixture’s ground wire to it. If
not, consult your electrician for proper grounding. After
the wires are connected, tuck them carefully inside the
post cup (H).
FINISHING THE INSTALLATION (Fig.1)
4. Align the fixture with the post and secure with screws
(H). (Fig.1)
10 Remove finial (A) followed by hex-nut (B), top cover (C),
top cover (D) and decorative ring (E) to install the
bulb(s) type B/E12 (not included) in accordance with the
fixture specification. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
11 Align decorative ring (E) followed by top cover (D) and
top cover (C) and secure with hex-nut (B) and finial (A).
Your installation is now complete. Return power to the
outlet box and test the fixture.
Fig. 1
  • Page 1 1

The Great Outdoors 8909-94 User manual

The Great Outdoors
Brand
The Great Outdoors
Model
8909-94
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents