Midmark Ultra-series Dental Chairs Installation guide

Brand: Midmark

Model: Ultra-series Dental Chairs

Type: Installation guide

TP200 20-42-FO-00012 Rev A1 C2169

DA5160i

Note

Use this kit to replace the capacitor on Midmark Ultra-Series Dental Chairs. J-Box component locations vary

depending on model and the options attached.

003-10205-00 Rev. AA1 (7/18)

Contents:

Capacitor ................1

Double-sided Tape .1

Special Tools:

none

Capacitor Replacement Kit Install [Kit# 002-10356-00]

Style G

Hydraulic Fluid Reservoir

Capacitor

Kit capacitor

Remove

existing

capacitor

Hydraulic Cover

Install Kit Capacitor...

A) Peel off tape film, rotate the kit capacitor to fit and

press it onto the chair frame near the hydraulic fluid

reservoir.

B) Connect the two wires you removed from the existing

capacitor to the kit capacitor terminals. Either wire

can be connected to either terminal.

C) Install the hydraulic cover.

D) Reconnect power to the chair.

WARNING

Always disconnect power from the chair

before removing any covers. Failure to do so

may result in personal injury.

Remove Existing Capacitor...

A) Rotate chair seat to one side.

B) Remove three screws and the hydraulic cover; locate

the existing capacitor.

C) Discharge the existing capacitor.

D) Disconnect the two wires from the existing capacitor.

E) Remove existing capacitor (it may be mounted with

a single screw or with double-sided tape).

WARNING

Use an insulated handle screwdriver to

jumper across both terminals to discharge

the capacitor before touching it. Failure to do so could

result in an electrical shock.

midmark.com

Midmark Ultra-series Dental Chairs Installation guide

Midmark Ultra-series Dental Chairs Installation guide

Midmark Ultra-series Dental Chairs Installation guide

Related papers

Other documents