ADVANCE RIC LI T 380 User guide

Type
User guide
RIC LI x80
RIC LI T x80
User Guide
2
Content
Welcome    4
Your hearing inruments    5
Inrument type    5
Getting to know your hearing inruments     6
Components and names    6
Controls    8
Hearing programs    9
Features    9
Daily use    10
Inserting and removing the hearing inruments    10
Turning on and o    14
Switching to andby mode    16
Adjuing the volume    17
Changing the hearing program    18
Further adjuments (optional)     18
Charging    19
Special liening situations    22
On the phone    22
Audio reaming with iPhone    22
Audio reaming with Android phone    23
Bluetooth    23
Audio induction loop (RIC LI T x80 only)    23
3
Maintenance and care    25
Hearing inruments    25
Ear pieces    27
Professional maintenance    29
Important safety information    30
Further information    34
Accessories    34
Operating, transport, and orage conditions    34
Disposal information    36
Symbols used in this document    36
Troubleshooting for hearing inrument    37
Country-specic information    38
Service and warranty    39
4
Welcome
Thank you for choosing our hearing inruments to 
accompany you through everyday life. Like anything new, 
it may take you a little time to become familiar with them.
This guide, along with support from your Hearing Care 
Professional, will help you underand the advantages 
and greater quality of life your hearing inruments oer. 
To receive the mo benet from your hearing 
inruments, it is recommended that you wear them every 
day, all day. This will help you get adjued to them.
The device may not look exactly like the guiding 
illurations in these inructions. We reserve the 
right to make any changes we consider necessary.
CAUTION
It is important to read this user guide and the safety 
manual thoroughly and completely. Follow the 
safety information to avoid damage or injury.
Before using your hearing inruments for the r 
time, fully charge them. Follow the inructions in 
the charger's user guide.
5
Your hearing inruments
This user guide describes optional features that 
your hearing inruments may or may not have.
Ask your Hearing Care Professional to indicate the 
features that are valid for your hearing inruments.
Inrument type
Your hearing inruments are a RIC (Receiver-in-Canal) 
model. The receiver is placed within the ear canal and 
connected to the inrument via a receiver cable. The 
inruments are not intended for children under the age 
of 3 years or persons with a developmental age of under 
3 years.
A power cell (lithium-ion rechargeable battery) is 
permanently built into your hearing inrument. This 
enables easy charging with Charging Station R or the 
optional Travel Charger RIC or Charging+ Station R.
The wireless functionality enables advanced audiological 
features and synchronization between your two hearing 
inruments.
Your hearing inruments feature Bluetooth® low energy*
technology allowing for easy data exchange with your 
smartphone, and for seamless audio reaming with your 
iPhone** and for some Android smartphones that support 
Audio Streaming for Hearing Aids (ASHA).
*  The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc., and any 
use of such marks by WS Audiology Denmark A/S of this product is under licenses. 
Other trademarks and trade names are those of their respective owners.
**iPad, iPhone, and iPod touch are trademarks of Apple Inc., regiered in the U.S. 
and other countries.
6
Getting to know your hearing inruments
It is recommended to familiarize yourself with your new 
hearing inruments. With the inruments in your hand 
try using the controls and note their location on the 
inrument. This will make it easier for you to feel and 
press the controls while wearing the hearing inruments.
If you have problems pressing the controls of your 
hearing inruments while wearing them, you can 
ask your Hearing Care Professional whether a 
remote control or a smartphone app to control your 
inruments is available.
Components and names
Ear piece
Receiver
Receiver cable
Microphone 
openings
Rocker switch (control, 
on/o switch)
Side indicator (red = right ear, 
blue = left ear) and receiver 
connection
Charging contacts
7
You can use the following andard ear pieces:
Standard ear pieces Size
Sleeve 3.0, Vented, Closed, 
Power
Eartip 3.0 Open
Eartip 3.0 Tulip
You can easily exchange the andard ear pieces. Read 
more in section "Maintenance and care".
Cuom-made ear pieces
Earmold 3.0
8
Controls
With the rocker switch you can, for example, switch 
hearing programs. The Hearing Care Professional has 
programmed your desired functions to the rocker switch.
Rocker switch function L R
Press briey:
Program up/down
Volume up/down
Tinnitus Function: level up/down
TV ream on/o
Press for about 2 seconds:
Program up/down
Volume up/down
Tinnitus Function: level up/down
TV ream on/o
Press for more than 3 seconds:
Turn on/o
   L = Left, R = Right
You can also use a remote control to change
hearing programs and adju the volume of your 
hearing inruments. With our smartphone app you 
have even more control options.
9
Hearing programs
1
2
3
4
5
6
Read more in section "Changing the hearing program".
Features
The Tinnitus Function generates a sound to
diract you from your tinnitus.
10
Daily use
To assure comfortable and easy use of your hearing 
inruments they are equipped with an onboard control 
element. In addition we oer an app for Android as well 
as iPhones which makes handling your devices even 
easier. Contact your Hearing Care Professional for 
downloading and inalling the smartphone app.
Inserting and removing the hearing inruments
Your hearing inruments have been ne-tuned for your 
right and left ear. Colored markers 
indicate the side: 
■  red marker = right ear
■  blue marker = left ear
Inserting a hearing inrument:
XFor Sleeves, take care that the bend of the Sleeve is 
in line with the bend of the receiver cable.
See the following illurations.
11
Correct:
Incorrect:
XHold the receiver cable at the bend closer to the 
ear piece.
XCarefully push the ear piece in 
the ear canal .
XTwi it slightly until it sits well.
Open and close your mouth to 
avoid accumulation of air in the 
ear canal.
XLift the hearing inrument and 
slide it over the top of your 
ear . 
12
■  It may be helpful to insert the right hearing
inrument with the right hand and the left
hearing inrument with the left hand. 
■  If you have problems inserting the ear piece, 
use the other hand to gently pull your earlobe 
downwards. This opens the ear canal and eases 
insertion of the ear piece.
The optional retention rand helps to securely retain the 
ear piece in your ear. To attach the optional retention 
rand:
XAlign the end of the retention rand with the at end of 
the receiver.
13
XThen press the retention rand towards the receiver 
until it clicks into place.
 To position the retention rand:
XBend the retention rand and 
position it carefully into the 
bottom of the bowl of your ear 
(refer to the picture).
14
Removing a hearing inrument:
XLift the hearing inrument and 
slide it over the top of your 
ear .
XIf your hearing inrument is 
equipped with a cuom shell 
or a mold, remove it by pulling 
the small removal cord toward
the back of your head.
XFor all other ear pieces: Grip the receiver in the 
ear canal with two ngers and pull it carefully out .
Do not pull the receiver cable.
Clean and dry your hearing inruments after usage. 
Read more in section "Maintenance and care".
Turning on and off
You have the following options to turn your hearing 
inruments on or o.
Via charger:
XTurning on: Take the inruments out of the charger.
The artup melody is played in your hearing 
inruments. The default volume and hearing program 
are set.
XTurning o: Place the hearing inruments in the 
charger.
15
Note that the charger mu be connected to the power 
supply. For details refer to the charger's user guide.
Via rocker switch:
XTurning on: Press and hold the lower 
part of the rocker switch until the 
artup melody arts to play. Release 
the rocker switch while the melody is 
playing.
The default volume and hearing
program are set. 
XTurning o: Press and hold upper 
or lower part of the rocker switch 
for several seconds. A power down 
melody is played. 
16
Switching to andby mode
Via remote control you can switch your hearing 
inruments to andby mode. This mutes the hearing 
inruments. When you leave andby mode, the 
previously used volume and hearing program are set.
Note:
■  In andby mode, the hearing inruments are not
turned o completely. They draw some power. 
Therefore we recommend to use andby mode only 
for a short period of time.
■  If you want to leave andby mode, but the remote 
control is not at hand: Turn your hearing inruments 
o and on again (via rocker switch or by shortly 
placing them in the charger until a green LED lights 
up). In this case, the default volume and hearing
program are set.
17
Adjuing the volume
Your hearing inruments automatically adju the volume 
to the liening situation.
XIf you prefer manual volume adjument, press the 
upper part of the rocker switch to increase the volume 
or press the lower part to decrease the volume.
Refer to section "Controls" for the setting of your 
rocker switch.
An optional signal can indicate the volume change. Once 
the maximum or minimum volume has been reached, you 
may hear an optional signal tone.
18
Changing the hearing program
Depending on the liening situation, your hearing 
inruments automatically adju their sound.
Your hearing inruments may also have several hearing 
programs which allow you to change the sound, if 
needed. An optional signal tone can indicate the program 
change.
XTo change the hearing program, press the rocker 
switch briey.
Refer to section "Controls" for the setting of the rocker 
switch. Refer to section "Hearing programs" for a li of 
your hearing programs.
The default volume is applied.
Further adjuments (optional)
You can also use the hearing inrument controls to 
change other features, for example, the level of the 
Tinnitus Function.
Refer to section "Controls" for the setting of your controls.
19
Charging
You have the choice between three charger options:
Charging Station R
Travel Charger RIC
Charging+ Station R
XPlace your hearing inruments in the charger.
XFollow the inructions in the charger's user guide. You 
can also nd useful tips for charging in the charger's 
user guide.
20
Low power indication
You will hear an alert signal to indicate the power cell 
is running low. The signal will be repeated every 
20 minutes. Depending on the usage of your hearing 
inruments, you have approximately 1.5 hours to charge 
your hearing inruments before they op working.
Note that the power cell runtime is reduced if too many 
features are used simultaneously.
Charging tips
You may have some queions on how to be charge 
your hearing inruments. Read the queions and 
answers below. If you have more queions, your Hearing 
Care Professional will help you.
"
How often do I need to charge the hearing
inruments?
We recommend charging the hearing inruments 
daily, even if the power cell is not empty. Charge them 
overnight so you can be sure to art your day with fully-
charged hearing inruments.
"
How long does charging take?
A full charging cycle takes approximately 4 hours (+/- 10 
mins).
After 30 minutes, it is possible to use your hearing 
inruments for up to 6 hours.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40

ADVANCE RIC LI T 380 User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI