2. Innovative
  3. KT-27

Innovative KT-27 User manual

  • Hello! I've reviewed the installation instructions for the KT-27 keyboard tray. This document details the necessary hardware and tools needed for installation, as well as step-by-step instructions for mounting the tray to your worksurface, including use of a mounting template. I'm ready to assist with any questions you have about the device or the installation process.
  • What hardware is included?
    What tools are needed for installation?
    What is the first step to installation?
KT-27 KEYBOARD TRAY
Installation Instructions
© 2022 Human Active Technology, LLC P517514 REV B
Hardware Included:
Tools Needed:
Phillips Head Screwdriver
8mm Wrench
(4x) M5 Srews
(4x) Acorn Nuts
Human Active Technology
800 524 2744
customerservice@team-hat.com
team-hat.com
PAGE 1 OF 1
KT-27 BASEFRAME MOUNTING TEMPLATE
Installation Instructions
© 2022 Human Active Technology, LLC P517508 REV B
1/2" 6 3/4"
3 1/8"
1/8"
Pilot hole
1/8"
Pilot hole
FRONT EDGE OF WORK SURFACE
1. Tape this mounting template to the underside of
worksurface.
2. Drill two (2) 1/8" diameter x 1/2" deep pilot holes
at marked locations. Be careful not to drill
through the worksurface.
3. Remove template and install one (1) #12 x 3/4"
wood screw into the front pilot hole. Leave a
gap of approximately 1/8" between the head of
the screw and the worksurface.
4. Slide baseframe onto screw, using the front
keyhole slot. Locate the second drilled pilot hole
and insert a #12 x 3/4" wood screw through the
slotted hole and tighten both screws. Drive
additional screws as required, minimum four (4).
Human Active Technology
800 524 2744
customerservice@team-hat.com
team-hat.com
/