Spin-Digger SDBL78 User manual

Use and Care Manual Spindigger Screw-Post

The Spindigger Screw-Post is a universal product serves a variety of purposes including:

Mailboxes, yard lights, fencing, etc. and is effortless to install in 6 easy steps.

1. Outdoors, remove the endcap from Spin-Digger, and tip Spin-Digger upside-down safely

over grass away from feet and pets. The rebar twist-tool will slide out. Set twist-tool

aside.

2. Firmly replace endcap on the top of Spin-Digger.

3. In the exact location you want to install Spin-Digger, thrust its screw-tip straight down

into the ground. Use the wall of a building as a reference to verify that the Screw-Post is

perpendicular to the ground. Adjust as needed.

• If ground is dry or otherwise resistant, add water to soften ground or use end of

rebar twist-tool, and a hammer if needed, to hand drill a cone-shaped hole four to

five inches deep. Then continue as indicated in point 4.

4. Twist Spin-Digger clockwise with your hands until you feel resistance.

5. Slide the rebar twist-tool through the two holes located two-thirds the way up the Screw-

Post, until the twist-tool forms a set of handles the same length on each side of the post.

6. While applying downward pressure on both handles, rotate the twist-tool clockwise until

the silver-gray screw-tip is fully embedded in the ground and is no longer visible.

Spindigger is made of all high-grade aluminum so will never rust or corrode. Upkeep is easy as

keeping the product clean.

If there are any questions or comments about product please call us at 1(800) 977-2626 or visit

us at https://spindigger.com/

Download PDF