2. Hubbell Control Solutions
  3. NX Dry Contact Module

Hubbell Control Solutions NX Dry Contact Module Installation guide

  • Hello! I'm here to assist you with the Hubbell NXDCIO and NXHDI installation instructions. This document provides details on integrating dry contact inputs and outputs into the NX Control System, including connection to the HubbNET network. It also covers the installation process, power requirements, and included components. I have read this document and am ready to answer your questions.
  • What is the purpose of the NXDCIO module?
    What is required for the NXDCIO to connect to the NX HubbNET network?
    What voltage is required for the power supply?
    What components are included in the NXDCIO kit?
3461B 081920
72-00663
™NXDCIO KIT
INSTALLATION INSTRUCTIONS
INTRODUCTION
Read and understand all instructions before beginning installation.
NOTICE: For installation by a licensed electrician in accordance with National and/or local Electrical Codes and the following instructions.
Conrm device ratings are suitable for application prior to installation. Use of device in applications beyond its specied ratings or in applications other
than its intended use may cause an unsafe condition and will void manufacturer’s warranty.
Use only approved materials and components (i.e. wire nuts, electrical box, etc.) as appropriate for installation.
NOTICE: Do not install if product appears to be damaged.
SAVE THESE INSTRUCTIONS!
DESCRIPTION
The Hubbell Control Solutions’ NX Dry Contact Module (NXDCIO) provides the means to incorporate dry contact inputs and outputs into the NX Control
System. The NXDCIO requires the NXHDI Network Device Interface Module to provide the means of connection to the NX HubbNET™ network.
INSTALLATION
1. Open the NXDCIO kit box. Make sure all the necessary parts are there. It should include the following: NXHDI Module, NXDCIO, Power Supply, Din Rails
& Screws, Metal Enclosure and Enclosure Cover. See Fig 1, 2.
2. Screw in the two Din Rail tracks inside the enclosure.
3. Snap the NXHDI onto the upper DIN Rail track, on the right side.
4. Snap the NXDCIO module onto the upper DIN rail track in the enclosure to the left side of the NXHDI Network Device Interface Module. See Fig 3
5. Plug the ribbon cable supplied with the unit into the matching connector on the NXHDI module
6. Connect the dry contact inputs on the IO ports. Note: The relay side is to be connected to the dry contact outputs. See Fig 4.
7. Snap the NX Power Supply on the lower DIN Rail track. Make sure to connect the 24VDC power leads to the NXHDO. See Fig 4. The power supply itself
needs the input AC power 120/277V 50/60 Hz.
Figure 1 Figure 2 Figure 3
Figure 4
701 Millennium Blvd. | Greenville, SC 29607 | (864) 678-1000 | www.hubbellcontrolsolutions.com
Copyright © 2020 Hubbell Control Solutions, a division of Hubbell Lighting, Inc. All rights reserved. All product and company names, logos and product
identiers are trademarks ™ or registered trademarks ® of Hubbell Lighting, Inc. or their respective owners. Use of them does not necessarily imply any
aliation with or endorsement by such respective owners.
/