VintageView Universal Wine Bottle Retention Straps Installation guide

Universal Wine Bottle Retention Straps

Assembly instructions for BRS3

For Vino Pins, IDR, or W Series

Includes 1 long base strap and 1 short neck strap

Press the loop (fuzzy) side of the Velcro, facing up, and

wrap the base strap around the wide side of the bottle

and the base Pin or Rod until the hook (rough) side of

Velcro meets.

Repeat with the neck strap, wrapping it around the neck

of the bottle and the Pin or Rod. Velcro.

For Vino Rails, Evolution Wine Wall,

or Wine Tower

Includes 2 long base straps

Press the loop (fuzzy) side of the Velcro, facing up, on the

lower 1/3 of the bottle and wrap one strap around both

the bottle and the Rod until the hook (rough) side of Velcro

meets.

Repeat with the other strap, just below the shoulder of the

bottle. Velcro.

PRO TIP: If you would like to hid the VintageView logo,

just rotate it behind or underneath the bottle!

This manual is also suitable for