2. Herman Miller
  3. Mode Desk

Herman Miller Mode Desk Product Instructions

  • Hello! I've reviewed the Mode Desk assembly instructions. This document provides detailed steps for assembling your new desk, including how to attach the legs, install the power strip bracket, level the desk, and if applicable, attach the storage cabinet and drawer handles. I'm familiar with the cable management features and the recycling instructions, and ready to answer any questions you have about the assembly process.
  • What tools are needed for assembly?
    How do I install the cable leg?
    How do I route cables down the slotted leg?
HermanMiller Mode Desk Assembly Instructions1BV1DH rev A
1
Parts Included
HermanMiller
Mode Desk Assembly
How to Assemble Mode Desk Plug
Step 2:
Install slotted cable leg (opposite from desired cabinet side if applicable).
Step 1:
Lay desk top face down on a so surface, secure with bolts.
Bolts for Table Top and Cabinet
Attachment
Tools Required
Leg Attachment Bolts
Allen wrench Drawer Handle attachment bolts Philips Screw Driver
HermanMiller Mode Desk Assembly Instructions1BV1DH rev A
2
Step 3:
Install power strip bracket on same side as slotted cable leg.
Step 4:
Install remaining legs and tighten all bolts with
wrench. Do not over tighten.
Step 5:
Flip desk upright. Level desk with included leveling glides if needed. If
storage, continue with this step.
Loosely t short bolts into storage legs on desired side. For le storage,
insert one bolt in the bottom of the front and leg and in the top of the
back leg. For right storage, insert one bolt in the top of the front leg and
the bottom of the back leg.
Note: If no storage, proceed to Step 8.
Step 6:
Li cabinet onto installed bolts and slide onto desk through keyhole slots.
Secure cabinet in place by bolting second bolt per leg into the upper hole
(aligned with threaded hole in leg). Tighten bolts in keyholes.
Step 7:
Attach drawer handles to drawer fronts. Repeat for all drawers.
Slide drawers into cabinet.
Disassembly for Recycling:
Materials Identication and Segregation:
Where possible, plastic components are marked with ASTM recycling
codes. Use these codes to identify material type for recycling. Non
marked components should be treated as mixed plastic. Ferrous metals
can be identied using a small magnet for recycling. Non-ferrous metals
should be separated and recycled separately. To disassemble product,
reverse the above installation steps
Step 8:
Cap holes in legs without storage using provided plugs.
Step 9:
To route cables down slotted leg, remove cover by pulling on one end. Insert
cables and reinstall cover by pinching ends into slot at one side. Press cover
into slot.
Warranty: For warranty information, visit hermanmiller.com/warranty.
Care and Maintenance: For information on the care and maintenance of your
product, visit hermanmiller.com/care-and-maintenance.
HermanMiller Mode Desk Assembly Instructions1BV1DH rev A
3
/