2. ITC
  3. 69640-X-X
69640-X-X

ITC 69640-X-X User manual

  • Hello! I'm your chat assistant. I've reviewed the installation instructions for the ITC Navigation Light 69640-X-X. This document provides detailed steps for installing the light, including both backnut and screw mount bezel options. It covers drilling, wiring, and using sealant to prevent water damage. I am ready to answer your questions about the installation process or specifications present in the manual. Let me know how I can assist you.
  • What size hole is required for mounting?
    What is the recommended mounting angle?
    What should be done to protect electrical connections?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
Backnut No Bezel Version | Mounting angle must be on vertical surface and 56.25 degrees to meet coast guard requirements*
1.
Wire the light based on the wiring diagram. Use silicone sealant around the light to prevent any ingress of water.
PARTS/TOOLS NEEDED:
Navigation Light
Screws
Bezel Mount Only
(not provided)
Power Drill
(not provided)
Marine Wire Connectors
(not provided)
Application Specific
Sealant
(not provided)
INSTALLATION CONSIDERATIONS
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• It is recommended that fuse protection be added to the positive (+) input.
• All electrical connections should be made inside a watertight junction box.
• *Visit https://www.uscgboating.org/regulations/navigation-rules.php for full navigation regulations.
Incoming
12V - 24V DC
Power
Red (+)Black (-)
Neutral (-)
Load (+)
Fuse
Nav Light
Drill a 7/8” hole in your mounting surface then feed the wires
through the pre-drilled hole.
Wire the light using the the wiring diagram. Use application
specific sealant around the light to prevent any ingress of
water. Screw on the back nut to the light until tight.
2.
Screw Mount Bezel Version | Mounting angle must be on vertical surface and 56.25 degrees to meet coast guard requirements*
1. Drill a 7/8” hole in your mounting surface and predril screw
holes. Feed the wires through the pre-drilled 7/8” hole.
2.
Wiring Diagram
Wire the light using the the wiring diagram. Use application
specific sealant around the light to prevent any ingress of
water. Screw on the bezel.
INSTALLATION INSTRUCTIONS
Modular Nav Light
Part#: 69640-X-X
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00153 • Rev A • 11/19/19
Page 1 of 1
/