2. Computers & electronics
  3. Warranty & support
  4. Warranty & support extensions
  5. ITC
  6. 69641
69641

ITC 69641 User manual

  • Hello! I have reviewed the Vertical Mount LED Navigation Light Installation Instructions for model 69641. This document provides details on safety precautions, step-by-step installation, and connection requirements for the product. I am ready to answer any questions you might have about installing or using the navigation light.
  • What should be done before installing any components?
    What is the required diameter of the mounting hole?
    Where should all electrical connections be made?
230 E. Lakewood Blvd. • P.O. Box 8338 • Holland, MI • 49422-8338
Phone: 616-396-1355 • Fax: 616-396-1152 • www.itc-us.com • [email protected]
Revision Date: 01/26/22
Vertical Mount LED Navigation Light Installation Instructions
(Part # 69641)
Product Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
*Disconnect power before installing, adding or changing any component.
*To avoid a hazard to children, account for all parts and destroy all packing materials.
*Do not use in damp or wet locations unless specified otherwise.
*Do not install any luminaire assembly closer than 6" from any curtain or other combustible material.
SERVICE
There are no user-serviceable parts inside. Opening unit will void warranty.
WARRANTY
For information on our warranty policy please visit our website at http://www.itc-marine.com/resources/warranty/
Installation Instructions:
Step 1: Remove bezel if not already disassembled.
Step 2: Determine the installation location for your light. Once determined drill a 0.5” hole.
Step 3: Connect wires to power source.
Step 4: Feed wires back through the hole and screw the light in place using the screws provided.
Step 5: Reattach bezel.
**All electrical connections should be made inside a watertight junction box.
/