2. justanswer
  3. W712320
W712320

justanswer W712320 Installation guide

  • Hello! I've reviewed the provided workshop manual for the 2006 Ford Fusion, Milan, and Zephyr heater core removal and installation. This document includes detailed steps for disassembling and reassembling the heater core, mentioning the removal of cover screws and dash panel seals. I am ready to assist you with any questions about these procedures or other aspects of the manual.
  • What should be done if a heater core leak is suspected?
    What is the first step in removing the heater core?
    How many screws secure the heater core cover?
11/10/21, 12:29 PM
2006 Ford Fusion • MotoLogic
https://www.motologic.com/car/f16b6d20-ca4d-012b-1090-fbb1677812c1/article/687d6160-4549-012a-fa3c-f1daae012027?returnPath=%2Fcar%2Ff1…
1/2
Report a problem with this article
Climate Control - Heater Core - Removal and Installation
SECTION 412-01: Climate Control 2006 Fusion/Milan/Zephyr Workshop Manual
REMOVAL AND INSTALLATION Procedure revision date: 06/30/2005
Heater Core
Item Part Number Description
1 W712320 Heater core cover screw (8 required)
2 18B300 Heater core cover
3 19C593 Dash panel seal
4 18476 Heater core
Removal and Installation
NOTE: If a heater core leak is suspected, the heater core must be pressure leak tested before it is removed from the
vehicle. For additional information, refer to Section 412-00.
1. Remove the heater core and evaporator core housing. For additional information, refer to Heater Core And
Evaporator Core Housing in this section.
2. Detach the wire harness from the heater core cover.
↻
11/10/21, 12:29 PM
2006 Ford Fusion • MotoLogic
https://www.motologic.com/car/f16b6d20-ca4d-012b-1090-fbb1677812c1/article/687d6160-4549-012a-fa3c-f1daae012027?returnPath=%2Fcar%2Ff1…
2/2
3. Remove the 8 heater core cover screws.
4. Remove the heater core cover.
5. Remove the dash panel seal from the heater core tubes.
6. Remove the heater core.
7. To install, reverse the removal procedure.
/