Boston Whaler 130 Super Sport Tool Holder Installation guide

Type
Installation guide

This manual is also suitable for

ACCESSORY INSTALLATION
INSTRUCTIONS
RAIL MOUNTED TOOL HOLDER
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/07/2010
REV. C
PROCEDURE NO.
AI-MS-013
Pa
g
e 2 of 2
1. PURPOSE
Provide step-by-step procedure for the rail mounted
cup holder installation.
2. SCOPE
This procedure is limited to the rail mounted tool holder
installation on the 130, 150 & 170 Super Sport.
3. DEFINITION
3.1. Not Applicable
4. RESPONSIBILITY
4.1. Not Applicable
5. TOOLS/EQUIPMENT REQUIRED
5.1. Hex Wrench (supplied)
5.2. Hardware (supplied)
6. SAFETY
6.1. Safety glasses or goggles are recommended.
7. FORMS
7.1. Not applicable
CONTENTS OF KIT PART #
1- TOOL HOLDER. . . . . . . . . . . . .1952626
2- CLAMSHELL BRACKET (SUPPLIED)
3- HARDWARE (SUPPLIED)
Page 1 of 2
ACCESSORY INSTALLATION
INSTRUCTIONS
RAIL MOUNTED TOOL HOLDER
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/07/2010
REV. C
PROCEDURE NO.
AI-MS-013
8. PROCEDURE
8.1. Place the tool holder on the rail at the desired location
(as shown).
8.2. Using the Hex Head wrench and the hardware
supplied, insert and tighten the bolts at the six (three
top & three bottom) locations on the clamshell clamp.
Rail Mounted tool Holder Installation Is Complete
Page 2 of 2
  • Page 1 1
  • Page 2 2

Boston Whaler 130 Super Sport Tool Holder Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI