ACCESSORY INSTALLATION
INSTRUCTIONS
RAIL MOUNTED ROD HOLDER
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/17/2010
REV. B
PROCEDURE NO.
AI-MS-017
Pa
e 2 of 2
1. PURPOSE
Provide step-by-step procedure for the rail mounted
rod holder installation.
2. SCOPE
This procedure is limited to the rail mounted rod holder
installation on the 130, 150 & 170 Super Sport.
3. DEFINITION
3.1. Not Applicable
4. RESPONSIBILITY
4.1. Not Applicable
5. TOOLS/EQUIPMENT REQUIRED
5.1. Hex Wrench (supplied)
5.2. Hardware (supplied)
6. SAFETY
6.1. Safety glasses or goggles are recommended.
7. FORMS
7.1. Not applicable
CONTENTS OF KIT PART #
1- ROD HOLDER. . . . . . . . . . . . .1952622
2- CLAMSHELL BRACKET (SUPPLIED)
3- HARDWARE (SUPPLIED)
Page 1 of 3