MULTIPLEX MDH Series Installation guide

Instructions

Manitowoc Beverage Systems Sellersburg, 2100 Future Drive, Sellersburg, IN 47172, Tel: 812-246-7000, www.manitowocbeverage.com

1/11

Subject: MDH Series Graphic Medallion

Removal & Installation

The graphic medallions on the MDH Series Ice/Beverage Dispensers are

made out of a flexible duratran that can be removed/replaced from the front of

the unit without the use of tools (back-lit merchandiser light box does not need

to be removed from the unit).

MEDALLION REMOVAL

1. Loosen and remove the 2 knurled screws from either the right or left side of the merchandiser frame starting with the bottom one first. Left

side removal illustrated below. Note: A Phillips head screw driver may be used if the screws are too tight.

2. Remove the end portion of the frame that holds the medallion into the merchandiser.

3. With the end portion removed pull the 2 clear plastic sheets apart inside the merchandiser to expose the medallion that is sandwiched in

between.

4. Pull out only the medallion leaving the 2 clear plastic sheet still inside the merchandiser.

5. To install / replace the medallion slide the medallion back in between the 2 clear plastic sheets, replace the end portion of the frame and

hand tighten the knurled screws.

MDH-302 MDH-402

This manual is also suitable for

Download PDF