2. BLOTZ
  3. B00-RT-242

BLOTZ B00-RT-242, B00-RT-242_4, B00-RT-243, B00-RT-243_2 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Condition block model B00-RT-242. This document outlines the steps for assembling the model, including gluing the supports, tabs, and rear support. It also specifies tools and materials needed for the assembly process. I am ready to answer your questions about the assembly or any other aspects of the document.
  • What type of glue is required?
    What can be used to clean joints?
    What tool is needed to remove sections from the sprue?
Conditions Block
B00-RT-242
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care
and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Note – In these instructions we painted the four tabs prior to assembly.
Remove the base and front support from the
sprue. Glue the support into the holes in the
front of the base.
Take the tabs and their supports.
Glue one support into the left end of the base as
shown above.
Slip the lug on the tab into the hole in the support,
then attach the second support the base as shown
above. Repeat this for the other three tabs.
Take the rear support and glue it to the base.
The completed condition block.
/