Aero Microaces Fokker Dr.1 Triplane Assembly Manual

Brand
Aero Microaces
Model
Fokker Dr.1 Triplane
Type
Assembly Manual
Fokker Dr.1 Assembly Guide
Stage 1 - Airframe
Attach P1 & P2 to either side of D1 along the lower edge of the part. This can be done while D1
is still attached to the parts sprue. Attach P3 to D9 and P4 to D16 whilst also on the sprue.
Remove D1 from sprue and slot and glue formers D4 and D5 in positions shown above.
Attach D2 to the front of D1 and add triangular fillets D3 for reinforcement.
Remove material from D10 using the laser etched marks on the front face of the part.
Attach W1 to the front of D10 and secure one of the 4mm x 1 mm neodymium magnets into the
hole provided.
Attach D8 and D9 to D7 as shown above. Add stickers S1 and S2 to D4 and D11 respectively.
Fokker Dr.1 Assembly Guide
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25

Aero Microaces Fokker Dr.1 Triplane Assembly Manual

Brand
Aero Microaces
Model
Fokker Dr.1 Triplane
Type
Assembly Manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents