S P E C F I L E
ET-PKV100H
Ceiling mount bracket for high ceilings
As of September 2011
SFL11A022
1 / 1
Weights and dimensions shown are approximate. Specifications subject to change without notice.
145
∅ 38
∅ 10 (∅ 13/32)∅ 9 (∅ 11/ 32)
(1-1/2)
Projector
10
× 13
(13/32
× 1/2)
9
× 13
(11/32
× 1/2)
Adjustable in
30 mm (1-3/16) steps
140
(5-1/2)
70
(2-3/4)
70
(2-3/4)
200
(7-7/8)
100
(3-15/16)
100
(3-15/16)
(5-23/32)
132
(5-3/16)
94
(3-11/16)
82
(3-7/32)
256 (10-3/32)
911– 1,481
(35-7/8 –58-5/16)
Specifications
Vertical correction angle: ±15°
Horizontal slant correction angle: ±15°
Horizontal turn correction angle: 360°
Dimensions (W × H × D): 176 × 830–1,400 × 226 mm
(6-15/16˝ × 32-11/16˝–55-1/8˝ × 8-29/32 ˝)
Weight: Approx. 4.1 kg* (9.0 lbs*)
Applicable bracket assembly: ET-PKV100B
The illustration shows the ceiling mount
bracket when it is combined with the
ET-PKV100B and the PT-VW330/VX400
is attached.
Parts
Projector mount bracket A (pole included) . . . . . 1
Projector mount bracket B (pole included) . . . . . 1
Pole joint bolt . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Washer (M6) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Hexagonal nut (M6) . . . . . . . . . . . . . . . . . . . . . . 1
Snap pin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Screws (M5 × 10) . . . . . . . . . . . . . . . . . . . . . . . . 4
Hexagonal torque wrench . . . . . . . . . . . . . . . . . . 1
*
Average value. May differ depending on models.
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
Dimensions
Description
This ceiling mount bracket is used when mounting a Panasonic projector to high ceilings.
NOTE: This ceiling mount bracket cannot be used by itself. Combine it with the optional ET-PKV100B bracket assembly.
C a u t i o n :
• Mounting should be done by a qualified technician.
• Make sure that the mounting (ceiling) area has sufficient strength.
• Read the enclosed mounting instructions thoroughly before starting.
• Do not use an electric screwdriver or impact driver to tighten screws. Use a torque driver or hexagon torque
wrench and tighten screws to the torque specified in the instructions.
• When the product is no longer going to be used, have it disposed of quickly by a professional disposal service.
/
