Page is loading ...
Connecting the Aerial
44
Unpacking
11
Installing the Base Stand
22
Operating Your Remote Control
33
66
Connecting to the Mains Socket
Turning the TV on for the first time
55
1. Connect the mains cable to the mains socket after you have completed all the
connections.
2. Switch on the POWER ON/OFF switch at the back of the TV. At this stage stage,
the TV switches to standby mode. The power LED on the front panel of the TV
will illuminate.
3. The button on the side panel of the TV or on the remote control to turn the TV
on.
Remove all packaging from the TV. Retain the packaging. If you dispose of it please
do so according to any local regulations.
Install the batteries correctly by following the polarity (+ and -)
indications in the battery compartment.
1. Press and lift the back cover to
open the battery compartment
of the remote control.
2. Insert two AAA size batteries.
Close the battery compartment
cover.
1. Lay the TV down on a at surface with the back side facing up. Please make sure to
place a soft cushioned material (such as a pillow or thick piece of foam) beneath the
screen.
2. Slide in the base stand until the screw holes are aligned. Secure the base stand with
the 4 screws.
TV with TV Base
Remote Control /
AAA Batteries x 2
(P.N.: 4033C261204-V2)
1
2
Do not connect the TV to the mains supply until you have completed all
the connections.
The first time you turn the TV on, it will go straight into INSTALLATION GUIDE.
Connect one end of the RF coaxial cable to the aerial socket on the wall and the other
end of the cable to the RF (75Ω) socket at the bottom of your TV.
Congratulations on the purchase of your new Logik LCD TV.
Your new TV incorporates the latest technology to enhance your viewing experience.
We would suggest that you allow about 20 mins for initial setup.
Please follow this guide for a successful rst time installation.
Well done, your new TV is now ready to use.
You will nd that there are many exciting features available. To get to know all these
features, please take some time to read the instruction manual provided with your TV.
26” HD Ready Digital LCD TV
Quick Start Guide
L26DIGB10
Instruction Manual Quick Start Guide Digital Switchover
Addendum
VGA INPUT
Y Pb Pr
L R SPD IF
AUD IO
VGA I NPUT
SCA RT
HDM I 1
HDM I 2
ANT
100 -240V ~ 50/6 0Hz
AC- INPUT
COMM ON IN TERFA CE
CARD FACE FRON T
OR
RF coaxial cable
(not included)
Language
Auto Tuning
English
INSTALLATION GUIDE
Language
Auto Tuning
English
INSTALLATION GUIDE
1. The default on-screen menu language is set
as English.
2. Press the button and then press the OK
button or the button to select Auto
Tuning.
3. A pop-up screen will be displayed, press the
OK button on the remote control to start
the Auto Tuning.
Screw
Slide in
Screws x 4
(P.N.209030427B1)
Language
Auto Tuning
English
INSTALLATION GUIDE
Please ensure aerial is plugged in!!
Then press OK button.
To the mains socket
OFF ON
STANDBY
SUBPAGE SIZE MIX
REVEAL
HOLD LIS T
INDEX
SUBTITL E
SLEEP ASPECT
TEXTTV/RADI OFREEZE
EPG FAV INFO
CH. LIS T SOU ND E XIT
PICTURE
STANDBY M UTE
AUDIO
RECALL
TV MENU SOURC E
+
CH
_
+
_
VOL
1 2 3
4 5 6
7 8 9 0
OK
/