2. West Elm
  3. Simii Newhouse Rectangular Meeting Table

West Elm Simii Newhouse Rectangular Meeting Table Assembly Instructions

  • I have reviewed the assembly instructions for the Simii Newhouse Rectangular Meeting Table. The document details the step-by-step process, from unpacking components to securing the worksurface and wire management clips. I'm ready to answer any questions you have about assembling your table.
  • What is the first step in assembling the table?
    What type of screws are used to assemble end and side rails to legs?
    What size are the screws used to attach the frame to the worksurface?
    What size screws are used to fasten Wire Management clips?
Page 1 of 1
Newhouse Table
Assembly Instructions
Component List
Legs (x4)
End Rail (x2)
Side Rail (x2)
Worksurface (x1)
  
M8 SHCS (x8)
Pan Phil #10-24 x 5/8” (x36)
Pan Head Allen Wrench
#12 x 3/4" (x8) 6mm. (x1)
Step 1: Remove Legs, Rails and Worksurface from
shipping carton.
Step 2: Assemble End rails and Side rails to legs
and fasten using enclosed M8 SHCS to create
frame table.
Step 3: Flip the worksurface over onto its face with
pilot holes facing upwards.
Step 4: Place the frame assembly onto the
worksurface aligning the holes on the worksurface
and fasten using enclosed Pan Phil#10-24 x 5/8”
Step 5: Fasten Wire Management clips with the
worksurface using enclosed Pan Head #12 x 3/4”
Step 4
Step 5
/