West Elm Simii Wake Flip Nest Table Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the simii Wake Flip + Nest table. This document contains step-by-step guidance on correctly assembling the table using components such as the legs, flip mechanism, cable clips, and screws. I'm here to help you with any questions you might have about the assembly process.
  • What type of screws are used to attach the mounting plates to the worksurface?
    How do you lock the table in the upright position?
    What is used to attach the legs?
    What size screw is used to fasten the cable clips?
Page 1 of 1
Wake Flip + Nest
Assembly Instructions
Component List
 
Legs (x2) Flip Mechanism (x1)
Worksurface (x1)
Truss Phil M6 (x8) Pan Head#12x1” (x20)
Pan Head#6x1/2” (x8) Cable Clip (x6)
Step 1: Place worksurface bottom side up on a non-
marring surface.
Step 2: Align holes on mounting plates with pre-
drilled holes on bottom side of worksurface. Fasten
each mounting plate to the worksurface using #12 x
1” Phillips Pan Head screws.
Step 3: Align holes on handle base with pre-drilled
holes on bottom side of worksurface. Fasten handle
base to worksurface with enclosed #12 x 1” Phillips
Pan Head screws.
Step 4: Position cable clips evenly along the cable
and fasten to bottom side of worksurface with
enclosed #6 x 1/2” Phillips Pan Head screws.
Step 5: Use handle assembly to release the
mechanisms and lock in the upright position.
Step 6: Critical step Complete installation of
Mechanism by fastening each mounting plate to
worksurface using enclosed #12 x 1” Phillips Pan
Head screws.
Step 7: Use handle assembly to release the
mechanisms and return to lowered position. Attach
each leg with enclosed M6 Truss Phil screws.
Step 2
Step 3
Step
5
To lock
/