KRUSADER HORN COVER, CHROME

7396

Page 1

THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN

RESULT IN POTENTIAL DEATH OR SERIOUS INJURY.

This indication alerts you to the fact that ignoring the contents described herein may negatively affect product per-

formance and functionality or damage the product itself or the product to which it is being attached.

STEP 1 Read and understand all steps in the instructions before starting the installation. Park the motorcycle on a hard, level surface and turn

STEP 3 Refer to PIC 1. Remove the existing horn assembly; disconnect the

STEP 4 Refer to PIC 1. Remove the two (2) flange head screws and bracket

from the horn assembly; save the screws, wire retainer, and bracket

STEP 5 Refer to PIC 2. Use a small flat-blade screwdriver to remove the

YOU WILL ALSO NEED:

Set of sockets and ratchet, set of hex wrenches, small flat-blade screwdriver

These installation instructions contain important information. Ensure that the end user receives this copy and is

INSTALLATION MAY REQUIRE CON-

TACT WITH THE ENGINE AND EX-

regarding the installation, use, and care of this product.

Page 2

STEP 8 Refer to PIC 4. Attach the horn to the new bracket with the existing nut; leave it loose for now.

STEP 9 Refer to PIC 4. Ensure that the wire retainer is installed as shown using the top screw to secure it;

attach the existing bracket to the new bracket with the two (2) existing flange head screws. Leave

WITH 1/4-20 SCREWS

SLIDE SPEED CLIPS ONTO

BRACKET, FLAT SIDE UP

TOP

ALIGN AND ATTACH

WITH EXISTING

FASTENER

Page 3