Rugged Ridge 17235.86 Installation guide

Brand
Rugged Ridge
Model
17235.86
Type
Installation guide

This manual is also suitable for

Jeep® A-Pillar Switch Pod (Left Side - 2007 - UP JK)
Page 1 17235.56Rev (1) 10/28/10
HARDWARE NOTE: Switch Pod has been
designed to reuse factory metal retainer
clips located on the back of factory trim.
DO NOT DISCARD.
Important! Please read instructions completely before installing Switch Pod.
Step 1. Using T20 Torx head
screw driver remove
left side sun visor.
Remove side plastic
retainer clip from upper
left side windshield trim
(Pic.1)
Step 2. Remove upper trim from
windshield frame (Pic.2).
P/N: 17235.56
Step 3. Pop lower A-pillar trim
from windshield frame.
(Pic.3)
(Pic.1) (Pic.2) (Pic.3)
Step 4. Using a small flat head
screwdriver remove the
retainer clips form trim
(Pic.4)
Step 5. Install clips to new A-pillar
(Pic.5)
Step 6. Use a box knife to cut
along switch locator
guides (Pic.6) (Pic.4) (Pic.5) (Pic.6)
Step 7. Install switch into cutout
(Pic.7)
Step 8. Snap new Switch Pod
into windshield guide
holes (Pic.8).
Step 9. Reinstall upper trim
as described in steps
1 - 2 (Pic.9)
Item List:
(1) A-Pillar Switch Pod - Left Side Switches sold separately
---------------------------------
17235.01 - Amber
17235.02 - Red
17235.03 - Blue
17235.04 - Green
(Pic.7) (Pic.8) (Pic.9)
  • Page 1 1

Rugged Ridge 17235.86 Installation guide

Brand
Rugged Ridge
Model
17235.86
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents