Minka Lavery 4951-267B Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Minka Lavery 4951-267B Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTALLATION INSTRUCTION FOR 4951
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
PREPARATION
1. Shut off the power at the fuse box or circuit
breaker box. If necessary, remove the old fixture,
including all mounting hardware.
2. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration.
ASSEMBLING THE FIXTURE (Fig. 1)
3. Place the glass panel (I) into the decorative ring
(K), then using the sheet metals (L) to compact
the glass panel (I).
4. Secure the decorative ring (K) to the bottom of
shade (G) with the screws (J).
5. Secure the mounting ring (M) of the shade (G) to
the iron plate (H) with the screws (F).
6. Install the light bulb(s) (not included) in
accordance with the fixture’s specifications (DO
NOT EXCEED THE MAXIMUM WATTAGE!) (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
MOUNTING THE FIXTURE (Fig.1)
7. Thread the two mounting screws (C) (Size: #8-
32*1.3”L) part way into the crossbar (B). Secure
the crossbar (B) to junction box (not provided)
with the junction box screws (A) (Size: #8-
32*0.6”L). The side of the crossbar (B) marked
“GND” must face out.
CONNECTING THE WIRES (Fig. 2)
8. Connect the fixture wires to the junction box wires
as shown in Fig. 2, making sure all wire
connectors are secured. If your outlet box has a
ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the mounting plate
using the green screw provided. After the wires
are connected, tuck them neatly inside the
junction box.
COMPLETING THE INSTALLATION (Fig. 1)
9. Raise the canopy (D) allowing for the mounting
screws (C) to protrude through the holes on the
canopy (D), then secure with the finials (E).
Your installation is now complete. Return the
power to the junction box and test the fixture.
Fig.1
Fig.2
Set#
-Crossbar
-Ground screw
-Mounting screw*2
-Junction box screws*2
A-016
/